Small Red Crocodile Connector

For Arduino, Smart Car, Robotics.
Small electric motor magnet for direct current (DC). Micro Motor 3V 5V 6V DC with cable conector male features:
- Operating voltage: 1.5V to 6V - Cable 16cm with male connector - DC current: 350mA - Torque max.: 15g / cm
- Max speed: 12000rpm
- Weight: 16.5 g

It is used to pass the current, power electrical and electronic circuits, fans, motors, among others. Banana Black Connector Type II ZL15 features:

Dupont Connector 2.54mm Female features:
- Connector for soldering or crimping
- Lot 100 units
- Ideal for your projects electronic, arduino, but can also be used with other microcontrollers

Battery Varta Industrial AA - 4006 LR06 Mignon 1,5V- pack 4unds features:
- 1.5V Varta Industrial LR06 Battery
- High quality, made in Germany
- Quantity: 4 units

A bridge rectifier KBPC5010 is an array of electronic components, which is present in most voltage sources; The bridge is formed regularly by 4 diodes, connected in a specific way, and its function is to transform the alternating current to direct current. Bridge Rectifier 50A/1000V KBPC5010 features:
- Metal housing
- Type of diode: bridge rectifier
- Type of bridge: a phase
- Maximum driving voltage: 1000 V
- Maximum driving current: 50 A
- Peak inverse voltage: 1 kV
- Direct voltage Vf (max.) To If: 1.1V @>

Characteristic: - Voltage regulator 50-220V AC 2000W
- Ideal to control the speed of AC motors
- Allows adjustment the output voltage between 50V and 220V
- Input voltage: 220V AC
- Regulation range: 50V to 220V AC
- Max current: 10A
- Max power.: 2000W
- Dimensions: 47 x 35 x 27mm

The meter built on the basis of a water rotor and a Hall effect sensor
Please note this is not a Accuracy. Pulse rate varies slightly depending on flow rate, fluid pressure, and sensor orientation. Water Flow Sensor 1-30l /Min YF-S201 features:
- Working voltage range: DC 5 ~ 18 V
- Allow pressure: water pressure below 1.75Mpa
- Accuracy (flow-pulse output): ± 1 ~ 30 l / min
- Use temperature: ‰ ¤ 80 ° C
- Load capacity: ‰ ¤ 10 mA (5Vdc)
- Operating humidity: 35% ~ 90% RH (frost free)
- Temperature: -25 ~ + 80 ° C
- Outlet diameter: 1/2 "
- Red wire: positive supply
- Wire Black: negative power supply
- Yellow Cable: signal output
- Color: black
- Size: 6.2x3.6x3.4 cm

It is very easy to make it work with an Arduino, PIC or any other microcontroller.
In its output pin we will be able to measure the PWM pulse width depending on the distance of the obstacle.
HC-SR04 Ultrasonic Sensor Distance Measuring Module features:
- Supply voltage: 5V (4.5V- 6V)
- Consumption: 30 mA typical, (35 mA max)
- Interface: VCC , GND, Signal
- Range: 2 cm to 3 meters
- Angle 15º
- LED indicator of measurement in progress
- Frequency: 40 kHz for 200 µs - Size: 30mm x 20mm
- Quantity: 1 unit
Useful links for Arduino / Raspberry programming and projects with boards Arduino / Raspberry:
Automatic robot operation with obstacle detection />