Solder Wire Tin Sn60Pb40 Lead 2.5% Flux 0.5mm 250g

Flux Solder Paste in Tin Can 100g features:
- Welding paste according to DIN EN 29454-1 1.1.2.C.
- Flux paste based on medium activity rosin.
- Easy to solder: copper, silver plated, zinc and nickel. Flux residues after welding do not cause corrosion of non-ferrous metals and may remain in the joints.
Operating temperature of up to 350 C.

Welding Wire 100g Tin 60/40 Sn/Pb Lead 2.5% Flux 0.7mm features:
- 100gr. 0.7mm diameter welding wire. 60% tin and 40% lead
- Fusing temperature 183 „ƒ / 190 „ƒ
- Alloy Sn60 Pb40
- Flux 2.5%
- Quantity: 1 unit

Welding Wire 100g Tin 60/40 Sn/Pb Lead 2.5% Flux 1.0mm features:
- 100gr. 1.0mm diameter welding wire. 60% tin and 40% lead
- Fusing temperature 183 „ƒ / 190 „ƒ
- Alloy Sn60 Pb40
- Flux 2.5%
- Quantity: 1 unit

The PCB PLUS cleaner is designed for printed circuit boards.
Dissolves waste flux, including resin.
The liquid does not attack the substrate or the structural components of the printed circuit boards.
The special brush to remove particles and smaller debris. Perfect for cleaning PCB after repair and assembly.
PCB Plus Cleanser Spray 400ml features:
- Form: spray
- Capacity: 400ml
Application:
- The product does not leave deposits
- It evaporates very fast
- Eliminates waste after welding
- Perfect in any electronic service
- The product does not react with most plastics used in electronics

Tin ideal for application in consumer electronics circuits. Welding Wire 250g Tin 60/40 Sn/Pb Lead 2.5% Flux 0.9mm.

Liquid Flux Alcohol Base TK83 100ml 
Flux liquid alcohol based for electronic welding. Type of flux: rosin
No Clean, Lead Free, Non-conductive. Ideally suited for manual tinning to restore solderability. Solids content 24%. max. soldering temperature 280ºC.

Type of chemical preparation: alcoholic stripper of printed PCB plates.
Alcohol-based cleaner to eliminate fluxes, dirt removal, flux residues in PCB.
has low impact on electronic components.
Alcohol PCB Cleaner 1l features:
- Form: liquid
- Capacity: 1l
- Alcohol PCB cleaner
PCB cleaner based on alcohol for the elimination of any residue from the printed circuit surfaces after welding, cleaning of the welding unit frames, templates and rosin screens, and the dissolution of the waste stream.
The liquid does not affect the substrate or components of the circuit board.

Flux gel syringe 1.4cm3 of RMA class, intended for SMT assembly and repairs. Flux gel can be applied through a sieve, pattern or from a syringe. Activators utilized in flux manufacturing process enable to leave its remnants after soldering on the package (as far as the process does not include washing phases).