Laminated Copper Clad Prototype PCB Circuit Board 10x15cm

Soldering Iron Cleaner with Brass Ball Holder features:
- Brass wire cleaner for solder tips with support
- It allows to remove the welding residues from the tips
- Cleans better and does not cause temperature drops as with sponges
- You do not need extra water to clean the tip
- Easy and effective cleaning at the tip
- Dimensions: diameter 50mm
- Support dimensions: 60x68mm

5x Strip 16 Pin Female Short features:
- Pin spacing: 2.54mm
- Insert position: Vertical
- Insert: Through
- Quantity: 5 units of strips of 16 female pins each

Blue 2 pole PCB mount screw terminal 5.08mm pitch Printed Circuit Board Terminal 3 poles 5.08mm pitch features:
Number of Contacts: 3
Pitch: 5.08mm
Number of Rows: 1
Mounting Type: PCB
Gender: Male
Allowable Section: 1.5mm2 (22- 14 AWG)
Termination method: screw
Type: screw terminal block
Nominal current: 16A
Nominal voltage: 250V
Color: blue
Material: Nylon 66
Depth: 10mm
Width: 7.5mm
Length: 10mm

Push button 6x6x4mm features:
-Touch Push Tact Switch mini electronic Arduino push button
-Measures: 6x6x45mm
-Quantity: 1 unit

Fotoboard Pre-Sensitized Photoresist Coated PCB Copper Laminate - One-Sided 15x20cm features:
- One side plate for prototype 150x200mm 35um
- Fiberglass

SN74LS47N BCD 7-Segment Decoder/Driver Integrated Circuit features:
- Blister: DIP16
- Number of pins: 16
- Step between pins: 2.54 mm
- Manufacturer: from China - Input voltage VDD: 4.75 - 5.25 VDC
- High level input voltage V (IH): 2 VDC
- Low level input voltage V (IL): 0.8 VDC
- Voltage of the input clamp diode V (IK): -1.5 - -0.65 VDC
- High level output voltage V (OH): 2.4 - 4.2 VDC
- Low voltage output voltage V (OL): 0.35 - 0.5 VDC
- Input voltage in V state (I on): 0.35 - 0.5 VDC
- Output voltage out of state V (I off): 15 VDC - High level input current I (IH): 20 μA - 0.1 mA
- Low level input current I (IL): -1.2 - -0.4 mA
- High level output current I (OH): - 50 μA

40x Female Male 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Compatible with 2.54mm male connectors
- High quality and good working conditions
- Easy to install and use

Graphite Varnish cCan be used for the elimination of discontinuities in the graphite layer in printed circuits. Creation or reconstruction of routes in printed circuits of low intensity. Protection of silver contacts from harmful direct contact of silver with rubber (in remote controls)