Power supply DC 24V 4.5A 100W

Latching Metal Switch 16mm Stainless Steel features:
- For panel N/A NO 2A 36V Stainless Steel On/Off
- Type of operation: On/Off
- Contact switch: 1 NA (normally open)
- Max Switch Classification: 2A/36VDC
- Type of terminal: Screw
- Body material: Stainless steel
- Button Material: Stainless steel
- Protection Classification: IP67 / IK08
- Operating temperature: -20C + 55C

Plastic Box features:
- Transparent color
- Dimensions: 22,80x16x5,90cm

Wide range of voltages, improved version.
Drop module.
They will use a multimeter to Check the output voltage and adjust the potentiometer.
3A DC Converter 4-53V Adjustable LM2596H Step Down Source features:

- Based on the LM2596HVS-ADJ regulator
- Rectification: Asynchronous
- Output Voltage: 3v ~ 40v DC (adjustable)
- Input Voltage: 4.5v - 53v DC
- Max Output Current: 3A (with heat sink)
- Ripple in output voltage: 30mV
- Frequency: 150KHz
- Max Conversion Efficiency: 92%
- Load Regulation: ± 0.5% - Voltage Regulation: ± 2,5%
- Operating temperature: -40ºC to + 85ºC
- Measurements: 43x 21x 14 mm

T-Cobbler Protoboard Extension Plate GPIO 40 Raspberry PI B+ Pin features:
- Shield expansion module for Raspberry Pi 2 and Pi 3, B and B +
- Dimension: 6 x 7.3x 1.9mm

2 Channel Relay Module 5V 10A for Arduino features:
- 5V relay module with 2 optocoupled channels
- This module can be controlled directly by the microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL)
- Channels: 2 (independent protected with Optocouplers)
- Supply voltage: 5V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- LED indicator: For each channel
- Dimensions: 40x 50mm

Screw Shield V2- Arduino ScrewShield UNO features:
Screw Shield V2 allows: - Being punctured directly to an Arduino Uno
- Facilitate the connection of different modules, such as sensors, relays, servos, buttons, potentiometers and more.

Store and transport your components in the most orderly and safe way with this organiser case. The case is made of sturdy material, has good fastenings and a handle.

Heat Shrinkable Tube 5 Colors 3 Meters Package features:
- Heat shrink tubing is used to connect electrical cables, isolate resistor and capacitor points, mark and protect cables Electrical, protect metal bars or tubes against corrosion and protect antennas.
- These heat shrink tubes are very flexible and of high quality. Made in EU
- Different sizes of 20 cm each are delivered:
* 1,6mm: black, brown, red, yellow, orange
* 2,4mm: black, brown , red, yellow, blue
* 3,2mm: black, brown, red, yellow, blue
- Quantity: 15 units
- Material: polyolefin
- Shrinkage ratio: 2: 1 (maximum reduce to 1/2 of its supplied diameter)
- Minimum shrinkage temperature: 115 ° C maximum 200 ° C