Power supply DC 12V 1.25A 15W

Embellisher features:
- Color black and red, white, yellow, orange
- Upper diameter: 0.9 cm
- Lower diameter: 1.5 cm
- Height: 1.6 cm
- Inside hole diameter: 0.6 cm

MQ-8 Hydrogen Gas Sensor Module features:
- Main chip: MQ-8 methane sensor and comparator LM393
- Working voltage: 5V
- Current: 150mA
- Digital output: TTL 0/1
- Analog output: analog voltage sensing value
- Quick response features:
- Detection concentration:
  100ppm- 10000ppm hydrogen H2
- Adjustable sensitivity with the potentiometer
- Size: 32mm x 20mmx 18mm

10x Photoresistor 5mm GL5516 LDR 5-10k for Arduino.
Photoresistor is a resistor whose resistance decreases when increasing the intensity of the light that falls on it. 10x Photoresistor GL5516 LDR features:
- Model: GL5516
- Spectral peak: 540nm
- Maximum DC voltage: 150V
- Maximum power: 90mW.
- Resistance with light (10lux): 5-10KΩ
- Resistance with darkness (0lux): 0.5MΩ
- Response time: 20ms
- Operating temperature: -30ºC - 70ºC

Camera module for Arduino, Raspberry Pi 2 and Pi 3, B and B +. VGA camera 640x480 OV7670 B 0.3MPx 30fps Cmos features:
> - Input voltage 2.5V-3V
- Operating power 60mW / 15fps VGA YUV
- Resolution VGA 640x480 pixels (30fps)
- Maximum frame rate 30fps VGA
- Flicker 50Hz / 60Hz automatic detection
- Lens size 1/6 "
- Angle of view 25 °
- Sensitivity 1.3V / (lux- seg)
- SCCB (Serial Camera Control Bus) interface
- Output format · 8 Bits
- YUV / YCbCr 4: 2: 2
- RGB 565/555/444
- GRB 4: 2: 2
- RAW RGB data
- High sensitivity Light operation
- Automatic adjustment
- Color level saturation - Edge enhancement
- Noise level

Resistor 470K Ohm 5% 0,25W 1/4W features:
-470 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

  Mini voltmeter with LED display 7 red 3-digit segments.
Simply connect the positive and the negative to turn it on and measure the voltage.   Mini voltmeter with LED display 7 blue segments 3 digits 3.5-30 VDC - 1% features:
  - Operating voltages (measurement): 3.5 - 30 VDC,
- Color of the LED segments: blue
- Update speed: approx. 500ms,
- Accuracy of the measurement: ± 1%,
- No need power supply: it is powered with the measured voltage,
- Cable length included: 10cm,
- Size: 30x12x9mm.

Grey Flat Cable GPIO 40 Pins M/F Raspberry Pi (RPi2, RPi3, B and B+) features:
-Length: 25cm
-Quantity: 1 unit
-Female connectors at both ends
-High quality and good working condition
-easy to install and use

Protoboard Breadboard 9x15cm features:
-PCB dimension: 9x15cm
-Hole diameter: 1mm
-Pitch: 2.54mm
-Bakelite with copper fields