20x M2.5x6 Nylon Screw

Electronic Prototype ABS Plastic Black Box 100x60x25 features:
- Box for electronic projects, power supply units, student projects,
amplifiers, etc
- Dimension 100x60x25 mm

20x M2x6 Nylon Screw features:
-Polyamide 6mm Thread Arduino Robot PCB Screw
-M2 Screw
-Thread: 6mm
-Round head
-Star (Philips) DIN7985
-Quantity: 20 units
-Color: white

Plastic Box features:
- Transparent color
- Dimensions: 22,80x16x5,90cm

Yellow Propeller for Micro Motor 3V 5 6V DC DIY Arduino.

20x M2x10 Nylon Screw features:
-Polyamide Thread 10mm Arduino Robot PCB Screw
-M2 Screw
-Thread: 10mm
-Round head
-Star (Philips) DIN7985
-Quantity: 20 units
-Color: white

This module includes the component BME280 that is translated into a digital signal.
The equipment uses the two I2C and SPI interfaces. The BME280 does not allow the module to be used as an altimeter as opposed to its successor BMP280.
Its 5-pin straight connector allows easy connection to other electronic boards. BME280 Digital Temperature Humidity Barometric Pressure Module features:
- Interfaces:
- I2C (up to 3.4 MHz)
- SPI (up to 10 MHz)
- Supply voltage: 1.8-5VDC
- Module operating range:
- Temperature: -40ºC to + 85ºC
- Humidity: 0-100%
- Pressure: 300-1100 hPa
- Resolution of the measures:
- Temperature: 0.01ºC
- Humidity: 0.008%
- Pressure: 0. 18Pa
- Accuracy of the measures:
- Temperature: +/>

Limit Switch with Wheel - 5A 250 Vac - 1 switched - Arduino features:
-Micro KW12-3 on / off switch
-Max Current: 5A -AC voltage: 125-250V
-Operating temperature: -40 to 70 degrees C
-Quantity: 2 units

IIC/I2C adapter PCF8574 LCD 1602 1604 2004 Interface features:
- Based on the PCF8574A chip
- Power: 5V
- Supports I2C Protocol
- A potentiometer for regulate contrast
- Dimensions: 19x42mm PCF8574 - & gt; the default address 0x20
PCF8574A - & gt; the default address 0x3F - You can change anyone between 0x20 and 0x27 depending on whether or not you have soldered pins A0 A1 A2 - With this module the communication between the Arduino and the LCD It is only made through two outputs, SDA and SCL
- Up to 8 LCD screens can be connected to the same I2C bus choosing a different address - Ideal for projects with ARDUINO and Raspberry Pi platforms - You can use it with PIC, AVR, STM32