Digital finger pulse oximeter ZM-700-0

mmWave 24GHz Sensor - Human Static Presence Lite Human Presence Module - human presence, FMCW, Configurable Underlying Parameter, Arduino support, Home Assistant, ESPHome

MyoWare Power Shield is designed to use two standard CR2032 coin cell batteries to power the MyoWare muscle sensor. These will be connected in parallel for extended capacity at a nominal 3.0V.

Sparkfun MyoWare 2.0 Muscle Sensor Development Kit  is an all-in-one electromyography (EMG) sensor kit compatible with Arduino. Just snap on a MyoWare 2.0 Shield, add some EMG sensor pads, connect the sensor to a muscle group and flex! The kit also includes the SparkFun RedBoard Plus is an Arduino compatible board and the MyoWare 2.0 Arduino Shield to connect the MyoWare® 2.0 sensor via a cable to the Arduino.

Sparkfun sensor  MyoWare® 2.0 from Advancer Technologies is a newer version of this producer's bestseller. The MyoWare 2.0 muscle sensor included in this kit has been redesigned from the ground up with a new compact and easy-to-use design, and has been updated with the latest, most advanced chipset to improve sensor performance and reliability. In addition, MyoWare has developed a range of shields that work with the sensor (in our LED shield offering, displaying sensor readings as LED lights).

This is your simple three conductor sensor cable with electrode pad wires. These cables measure 24" long and feature a 3.5mm audio jack on one end with snap type receptacles for biomedical sensor pads.

This detection module combines a phototransistor and an LED that, when placed on a finger or ear lobe, provides a reading.
By reading this signal you can interpret a change in the signal as a heartbeat.
Keep in mind that this is a sensitive module and you will experience the noise from home lights and other sources, since minimizing the lighting of the unit will help get the readings.
Heartbeat sensor Arduino features:
- Connection pins:
- S: Analog output
- (+): Power supply 3-5 VDC,
- (-): GND.
- Length: 18mm,
- Width: 18mm,
- Height: 4mm,
- Operating temperature: -40ºC to + 85ºC.

This Shield provides a 3.5mm connector where you can connect a three-electrode sensor cable, allowing you to test and use the MyoWare muscle sensor without actually connecting it to your person.

Microwave radar presence and motion sensor using FMCW technology, compatible with Arduino and Raspberry Pi.

This is the MyoWare Muscle Sensor Development Kit, an Arduino-powered electromyography (EMG) sensor kit that gives you the MyoWare, each MyoWare Shield and everything you need to connect them all together.

This a pack of 10 disposable electrodes is for biomedical measuring including EEG. Best suited for monitoring of neuro- and bio-feedback purposes. These are a single use, however very user friendly thanks to the latex-free gel.

This is not a medical device and is to be used for strictly educational purposes.