Momentary Switch Push Button Red N/O 7mm Momentary Switch Push Button Red N/O 7mm features: - Momentary pushbutton N/O (normally open)- Red button- Dimensions approx. 7 mm x 27 mm- Recessed with nut and washer- Load current (supported): 1A to 230V / 2A to 125V- Drill to embed: 7 mm +/- 0.2- Operating temperature: -55º to +85ºC Code K0156 Available Price €0.45
Wireless communication module APC220 RF kit APC220 433 MHz long range wireless modules with USB programming interface. The set provides wireless communication with a range of up to 1000 metres. Easy to configure solution for remote control of e.g. a robot. Code W0117 ✗ Out-of-Stock Price €48.90
Potentiometer B1K Linear Potentiometer B1K Linear features: -1k OHM kΩ - linear potentiometer 1k Arduino -Tolerance: +/- 20% - Power: 0.125W Code K0065 Available Price €0.99
Resistor 4,7K Ohm 5% 0,25W 1/4W Resistor 4,7K Ohm 5% 0,25W 1/4W features:- 4.7K Ohm-Type: Carbon film-Tolerance: ±5%-Power: 0.25W-Dimensions: 2x7mm Code D0017 Available Price €0.08
LED Diode Assortment Kit 30 pcs 5mm red, green, yellow LED Diode Assortment Kit 30 pcs 5mm red, green, yellow features:- Lens color: red, green, yellow - diffuse- Size: 5mm- Operating current: 20mA- Voltage (red) 1,8V-2,3V- Voltage (green) 3,2V-3,4V- Voltage (yellow) 1,8V-2,3V- Anode (A): Positive (long leg): 28mm- Catode (K): Negative (short leg): 25mm - Operating temperature: -25ºC/80ºC- Welding temperature: +260ºC - Quantity: 30 units*10x red*10x green*10x yellow Code P0011 Available Price €0.06
Desoldering Wire 2.5mm High grade in the absorption of tin for professionals.Copper mesh roll for desoldering electronic components.Desoldering Wire 2.5mm features:- Material: Copper- Length: 1.5m- Width: 2.5mm Code H0007 Available Price €1.79
Electric precision drill & gringer 12V Electric precision drill & gringer 12V features: - electric drill: 12000 rpm, with on/off switch - grinder stone: 2 pcs - engraving bit: 2 pcs - collet: 2 pcs - direct driven Specifications power: - 4 W (no load) / 16 W (load) / max. 20 W - speed: 12000 rpm - power supply: 12 VDC 0.4 A (not incl.) - drilling Ø: 1 mm Code H0157 ✗ Out-of-Stock Price €13.99
M3x10 Nylon Hexagonal Splitter 20x M3x10 Nylon Hexagonal Splitter features: -PA66 material -Type: female / female -Thread size / M3 inner diameter -Body length: 10mm -Quantity: 20 units -Color: white Code H0084 Available Price €0.29
Temperature Sensor Module MLX90614ESF-DCI GY-906 The GY-906DCI is a plate-mounted temperature sensor, based on an integrated 3 V infrared thermometer, single zone, medical precision, compensated gradient, within 15 cm the accuracy is high, approximately 0.5 degrees Code S0147 Available Price €39.90
Temperature Sensor Module MLX90614ESF-BAA GY-906 The GY-906 BAA is a plate-mounted temperature sensor, based on an integrated 3 V infrared thermometer, single zone, medical precision, compensated gradient, within 3 cm the precision is higher, approximately 0.5 degrees Code S0145 Available Price €9.95
All-in-one air quality sensor ZPHS01B: CO2, PM2.5, CH2O, O3... ZPHS01B is an all-in-one air quality module, which integrates laser dust sensor, infrared CO2 sensor, electrochemical formaldehyde, ozone and carbon monoxide sensors, VOC sensor, NO2 sensor, temperature and humidity sensor. Code S0151 ✗ Out-of-Stock Regular price €145.90 -€6.00 Price €139.90
Thermistor NTC 50.0K 5% MF52A epoxy resin coating resistor NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance. Thermistor NTC 50.0K 5% MF52A epoxy resin coating resistor features:Size: 3mmRated resistance: R25 = 50.0kB value 25/85 = 3950°KRated power: ‰¤ 50mWTolerance:± 5%Operating temperature: from -40°C to +125°C Tinned steel wire 25mm Code D0091 Available Price €0.49
Infrared LED Flame Sensor 5mm Led infrared sensor.Detector of the source of fire or flame, can detect a flame or wavelength 760 nm-1100 nmParticularly sensitive to the flame spectrum.This optical flame sensor is a device that detects the existence of combustion by the light emitted by it. Infrared LED Flame Sensor 5mm features: - Range of light, Distance of 80 cm.- Angle detection of about 60 degrees,- This light can be detected by an optical sensor,- Can be captured by digital inputs and analog inputs of Arduino. Code S0132 Available Price €0.45
Non-contact temperature measuring thermometer Uni-T UT300H The UNI-T UT300H temperature meter, which uses the latest technology, enables temperature measurements in the range of 32°C-42.9°C. The high accuracy of the device enables fast and accurate monitoring of body temperature as well as other environmental elements, e.g. objects, food, liquids, etc. Code H0313 Last items in stock Regular price €34.50 -€4.55 Price €29.95
Thermistor NTC 10.0K 5% MF52A epoxy resin coating resistor NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance. Thermistor NTC 10.0K 5% MF52A epoxy resin coating resistor features:Size: 3mmRated resistance: R25 = 10.0kB value 25/85 = 3950°KRated power: ‰¤ 50mWTolerance:± 5%Operating temperature: from -40°C to +125°C Tinned steel wire 25mm Code D0090 Available Price €0.49
Gravity: I2C BME280 Environmental Sensor The BME280 is an environmental sensor (SEN0236) integrating a temperature sensor, a humidity sensor and a barometer. Powered from 3.3 V to 5 V with I2C and SPI interface. Measuring range: temperature: -40 °C to 85 °C, humidity: 0 %RH to 100 %RH, pressure: 300 hPa to 1100 hPa. Code DF017 Available Price €19.95
DS18B20 Digital Temperature Sensor Probe 10m Encapsulated with water resistant stainless steel with sensor dimensions 5,5 * 50mm, cable length 10m. DS18B20 Digital Temperature Sensor Probe 10m features:- Based on the DS18B20 chip- Supply voltage: 3 ~ 5.5V- Consumption <5mA- Measuring Range: -55 °C to 125 °C- Accuracy: +/- 0,5ºC- Outputs: - GND black - Vcc red - Yellow digital output- Inocidable steel- Cable length: 10m Code S0127 Available Price €14.99
Temperature Sensor Module MLX90614ESF-BCC GY-906 The GY-906 BCC is a plate-mounted temperature sensor, based on an integrated 3 V infrared thermometer, single zone, medical precision, compensated gradient, accuracy within 5 cm is approximately 0.5 degrees higher Code S0146 Available Price €17.50
DS18B20 Temperature Sensor 0.5ºC TO-92 Also available with waterproof casing and 100cm cable and 200cm. DS18B20 Temperature Sensor TO-92 0.5ºC Precision 5V Integrated features:- Device function: Temperature sensor- Type of output: Digital- Supply voltage: 3V to 5.5V- Accuracy: ± 0.5ºC- Temperature threshold: Programmable- Operating temperature: -55ºC to + 125ºC- Encapsulated: TO-92- Supply current: 1.5mA Code S0014 Available Price €1.95
Precision Temperature Sensor TO-92 LM335 LM335Z-ST Precision Temperature Sensor TO-92 LM335 LM335Z-ST features:- Power supply from 5 to 30 Vdc- Connection through analog input- Temperature range from -40ºC to 100ºC- Linearity +10 mV / ºK- Accuracy of measurement: ± 2 ° C- Manufacturer: Texas Instruments Code S0120 Available Price €3.99
SONOFF SNZB-02 - ZigBee Temperature And Humidity Sensor SONOFF SNZB-02 is an elegant mini wireless intelligent temperature and humidity sensor via ZigBee, through its Bridge(required). Program and create scenes based on the detected values. Maintain a stable temperature in your home. Code WS039 Available Price €9.90
DS18B20 Digital Temperature Sensor Probe 10m Encapsulated with water resistant stainless steel with sensor dimensions 5,5 * 50mm, cable length 10m. DS18B20 Digital Temperature Sensor Probe 10m features:- Based on the DS18B20 chip- Supply voltage: 3 ~ 5.5V- Consumption <5mA- Measuring Range: -55 °C to 125 °C- Accuracy: +/- 0,5ºC- Outputs: - GND black - Vcc red - Yellow digital output- Inocidable steel- Cable length: 10m Code S0127 Available Price €14.99
Solar Power Manager 5V The solar power management module with the CN3065 chip is ideal for IoT (Internet of Things) projects with renewable energy. Compared to the previous version of the module, improvements have been made to the energy management of the connected battery. Code DF025 Last items in stock Regular price €17.50 -€4.00 Price €13.50
Infrared LED Flame Sensor 5mm module Led module infrared sensor for ArduinoDetector of the source of fire or flame, can detect a flame or wavelength 760 nm-1100 nmParticularly sensitive to the flame spectrum.This optical flame sensor is a device that detects the existence of combustion by the light emitted by it. Infrared LED Flame Sensor 5mm module features:- 4 Pins Output: - A0: analog output - D0: digital output - GND: ground connection - VCC: 5V module power- Range of light, Distance of 80 cm.- Angle detection of about 60 degrees,- This light can be detected by an optical sensor,- Can be captured by digital inputs and analog inputs of Arduino. Code S0133 Available Price €1.39
All-in-one air quality sensor ZPHS01B: CO2, PM2.5, CH2O, O3... ZPHS01B is an all-in-one air quality module, which integrates laser dust sensor, infrared CO2 sensor, electrochemical formaldehyde, ozone and carbon monoxide sensors, VOC sensor, NO2 sensor, temperature and humidity sensor. Code S0151 ✗ Out-of-Stock Regular price €145.90 -€6.00 Price €139.90
Thermistor NTC 5.0K 5% MF52A epoxy resin coating resistor NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance. Thermistor NTC 5.0K 5% MF52A epoxy resin coating resistor features:Size: 3mmRated resistance: R25 = 5.0kB value 25/85 = 3950°KRated power: ‰¤ 50mWTolerance:± 5%Operating temperature: from -40°C to +125°C Tinned steel wire 25mm Code D0089 Available Price €0.49
DS18B20 Waterproof Digital Temperature Sensor Probe 3m Encapsulated with water resistant stainless steel with sensor dimensions 6 * 50mm, cable length 300 cm. DS18B20 Waterproof Digital Temperature Sensor Probe 3m features:- Based on the DS18B20 chip- Supply voltage: 3 ~ 5.5V- Consumption <5mA- Measuring Range: -55 ° C to 125 ° C- Accuracy: +/- 0,5ºC- Outputs: - GND black - Vcc red - Yellow digital output- Inocidable steel- Cable length: 3m Code S0008 ✗ Out-of-Stock Price €4.85
Digital Thermometer with External Temperature Probe - Immerse the probe in the fish tank to measure the water temperature Digital Thermometer with External Temperature Probe features: - Cable length: 1m- LCD screen- Temperature range: -50 C ~ + 70C- Powered by 2 batteries x LR44 / AG13 button (included)- Cable length: approx.100cm- External Dimensions: 48 x 28.5 x 15.2 mm- Dimension LCD screen: 35 x 16 mm- Color: Black- Used to measure the temperature in: the rooms, the aquarium, terrarium in the heating system, in the car, fridge, freezer Code S0039 Available Price €2.79