RJ45 8p8c Cat5e Ethernet network connector for crimping

Terminal for JST PHR Female Connector 2mm features:
Manufacturer JST Connector series: PH Connector: contact Type of connector: female Type of connector: conduit-plate Mechanical assembly: crimped Working voltage: 100V Working current: 2A Material: phosphor bronze Cable size: 30AWG..24AWG Compatible with: JST PHR-2 Female 2 PIN 2mm Connector JST PHR-2 Female 3 PIN 2mm Connector PH series data sheet

This module is a timed switch that allows you to program several types of applications such as lights. Time Switch Module 12V NE555 Monostable Switch Delayed features:

Sonoff ZBMINI is a universal switch controlled by ZigBee. It works with 230V voltage and enables the control of any device from anywhere in the world, controlled by your mobile phone or voice assistants such as Alexa. Bridge requiered

Network tool set (10 pieces) for the construction of telephone and network cabling (RJ45, RJ11, RJ12) in a practical closed case. Crimper, tester, cable detector, cable stripper, screwdrivers, Rj-45 connectors, etc.

DC Gear Motor 6V 148 Arduino features:
- Voltage: 3 to 6Vdc
- Speed without load: 100 RPM to 6Vdc
- No-load current: 90mA to 3Vdc - 180mA to 6Vdc
- Reduction: 1:48

LITHIUM POLYMER BATTERY Battery LIPO 2800mAh 3.7V features:
-Battery type-lithium polymer. - Type of battery terminals- 3 wires. -Voltage of the battery-3.7 V -Capacity of the battery- 2800 mAh. - Embedded PCM security chip (protection against overload, over discharge, short circuit). Dimensions: -Length / depth of the battery- 78 mm -Width / diameter of the battery- 100 mm It has three cables with a 3-pin connector with a separation of 2 mm. Cables: Red: positive. Black: negative. Yellow: thermistor output.

The module has two outputs: analog A0 and digital D0
Digital output D0 - signal 0 appears or 1 depending on the threshold setting
The threshold is set with the potentiometer
The sensor can be used for example:
Automatic watering for potted plants
With this module you will be able to measure the humidity of the soil, so that you will be able to control the humidity level of the soil of your plants
Characteristic:
Operation: 3.3V -5V
- Sensitivity adjustable by potentiometer
- Dual output mode: analog and digital
- Red LED - power indicator
- Green LED - indicator digital switching output
- PCB measurements: 3 x 1.5 cm
- Probe measurements: 6 x 3 cm

USB Cable for Arduino Type A-B features:
- Length: 50cm
- Color: Blue