Resistor 220 Ohm 5% 0,25W 1/4W

Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32. MPU-6050 Accelerometer Module + Gyroscope 3 features:
- Chip: MPU-6050
- Power supply: 3V-5V
- Operating current: 5mA
- Communication: I2C
- 16-bit analog-digital converter on all axes
- Gyroscope scales: ± 250, ± 500, ± 1000 and ± 2000 ° / sec (dps) (programmable by the user)
- Accelerometer scales: ± 2g, ± 4g, ± 8g and ± 16g (programmable by the user)
- Dimensions: 14 x 21 x 1.3mm
- Quantity: 1 unit (1 strip of 8 pin + 1 strip of 8 layered pin)

5V USB powered water pump. Submersible pump for aquariums. It doesn't make a lot of noise while you're working.

Protection box for Arduino UNO R3 made of high quality acrylic material. Arduino Uno Transparent Acrylic Box R3 features:
- Compatible with Arduino UNO
- Material: transparent acrylic
- External dimensions: 80x 65x 18.5mm

Housing for 16x2 character LCD screens.
The screen is fixed to the housing with 4 screws.
1602 LCD display case features:

- Transparent acrylic shell,
- Includes screws,
- Dimensions: 90x40x55mm.

Modern compact digital multimeter with large LCD display that provides a better user experience.

This multimeter complies with IEC61010 standards: in pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) and double insulation.

Ideal for building a car with obstacle detector, light follower.
Includes battery compartment for 4 AA batteries and ignition switch. (batteries not included). 4WD Robot Smart Car Chassis 4x Wheels DIY features:
- Voltage: 3 to 6Vdc
- Speed without load: 100 RPM to 6Vdc
- No-load current: 90mA to 3Vdc - 180mA to 6Vdc
- Dimensions of the wheel: diameter 65mm - width 26 mm

2 Channel Relay Module 5V 10A for Arduino features:
- 5V relay module with 2 optocoupled channels
- This module can be controlled directly by the microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL)
- Channels: 2 (independent protected with Optocouplers)
- Supply voltage: 5V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- LED indicator: For each channel
- Dimensions: 40x 50mm

This connector can be used in most modeling projects.
It is ideal for small Lipo and NiMH connection. JST Male Connector 15cm AWG18 features:
- Type: JST male connector for RC BEC Lipo
- Color:
- Black: low power polarity
- Red: high power polarity
- Length: 20cm