Resistor 2M Ohm 5% 0,25W 1/4W

Resistor 51K Ohm 5% 0,25W 1/4W features:
- 51 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Male 40 Pin Header 1x40 features: Type: Male, Insertion position: Vertical, Separation between pins: 2.54mm

Resistors 47K Ohm 5% 0,25W 1/4W features:
-47K Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

High grade in the absorption of tin for professionals.
Copper mesh roll for desoldering electronic components.
Desoldering Wire 1.5mm features:
- Material: Copper
- Length: 1.5m
- Width: 1.5mm
- Desoldering Braid Solder Remover Wick 1.5mm / 1.5m
- Pure copper braid construction
- Quick removal welding
- Excellent thermal for a faster and safer desoldering

10x Photoresistor 5mm GL5516 LDR 5-10k for Arduino.
Photoresistor is a resistor whose resistance decreases when increasing the intensity of the light that falls on it. 10x Photoresistor GL5516 LDR features:
- Model: GL5516
- Spectral peak: 540nm
- Maximum DC voltage: 150V
- Maximum power: 90mW.
- Resistance with light (10lux): 5-10KΩ
- Resistance with darkness (0lux): 0.5MΩ
- Response time: 20ms
- Operating temperature: -30ºC - 70ºC

10x Female-Male Cables 20cm Jumpers Dupont features:
-Length: 20cm
-Quantity: 10 cables
-Connectors have male and female header contacts at either end
-Compatible with male and female connectors 2,54mm
-High quality and good working conditions
-Easy to install and use

This module includes the BMP280 component that converts atmospheric pressure, temperature and humidity with high precision into a digital signal.
The equipment uses the two I2C and SPI interfaces. The very good measurements made by the BMP280 allows the module to be used as an altimeter.
Its 5-pin straight connector allows easy connection to other electronic boards. BMP280 Temperature Barometric Pressure Sensor Module/SPI features:
- Interfaces:
       -I2C (up to 3.4 MHz)
       -SPI (up to 10 MHz)
- Supply voltage: 1.8-5VDC
- Module operating range:
       - Temperature: -40ºC to + 85ºC
0-100%
       - Pressure: 300-1100 hPa
- Resolution of the measures:
       - Temperature: 0.01ºC

Mini DC Converter 1.8A Downstream Voltage Regulator 4.7-23V to 1.0-17V features:
- Voltage Drop Module
- Use a multimeter to check the output voltage and adjust the potentiometer
- Small size: 17mm x 11mm
- Input voltage: 4.75-23V
- Output voltage: 1.0-17V
- Current output: 1.8A (peak max. 3A)
- Operating temperature: -40 to + 85 ºC
- Operating frequency: 240kHz
- Conversion efficiency: up to 96%
- Output ripple: 30mV (no-load) - Voltage regulation: ± 2.5%