Cable 1x0.35 Flexible Single-pole 0.35mm blue 3m Characteristic: -Low voltage electric cables -Normal: EN 50525-2-31 -Number of conductors: 1x0.35mm2 -Service voltage: 300 / 500V -Service temperature: at 70ºC -Resistance at 20ºC: 55.0 Ohm / Km -Weight (Kg / Km): 7 -Outer diameter: 2.4mm -Length 1m Code K0035 Backorder Price €0.45
Panasonic rechargeable battery NCR18650B 3400mAh Li-ion Panasonic rechargeable battery NCR18650B 3400mAh Li-ion 3,6V features: - Nominal capacity: 3350mAh (0.2C, 2.5V discharge) - Minimum capacity: 3250mAh (0.2C, 2.5V discharge) - Charging voltage: 4.2 ± 0.05 V - Nominal voltage: 3.6V - Charging method: CC-CV (constant voltage with limited current ) - Charging current: standard charge: 1625mA, - Charging time: standard charge: 4 hours, - Max. Discharge current: 6500 mA (ambient temperature 25 °) - Discharge cut-off voltage: 2.5V - Cell weight: 47.5g maximum - Cell dimension: Height: 65.30 mm maximum, Diameter: 18.50 mm maximum - Operating temperature: charge: 0 to 45 ° C, discharge: -20 to 60 ° C Code PP025 ✗ Out-of-Stock Price €9.95
Cable 1x0.35 Flexible single-pole 0.35mm red 3m Characteristic: -Low-voltage electric cables -Standard: EN 50525-2-31 -Number of conductors: 1x0.35mm2 -Service voltage: 300 / 500V -Service temperature: at 70ºC -Resistance at 20ºC: 55.0 Ohm / Km -Weight (Kg / Km): 7 -Outer diameter: 2.4mm Code K0033 Backorder Price €0.45
LM2596 DC Voltmeter Converter 3A Step Down Adjustable Power Descent module.Use a multimeter to check the output voltage and adjust the potentiometer.Control of tension.LM2596 DC Voltmeter Converter 3A Step Down Adjustable Power features:- Input voltage: 4.5-38V- Output voltage: 1.25-36.5V- Current output: 2A (max 3A with heat sink)- Operating temperature: -40 to + 85 ºC- Operating frequency: 150KHz- Efficiency conversion: up to 92%- Load Regulation: +/- 0.5%- Voltage Regulation: +/- 2.5%- Protection over temperature: the output switches off automatically- Size: 62mm x 38mm x 15mmPrincipal functions:- Step-down converter with overcurrent protection- Voltmeter up to 40V, remember to set the input voltage to 4.5V Code A0013 Available Price €3.99
SONOFF GK-200MP2-B Full HD Wifi Security Camera This Sonoff GK-200MP2-B Wifi security camera captures in Full HD 1080P all 360 degrees both day and night. It offers instant motion alert, motion detection with infrared night vision, and two-way audio, so you can hear and speak through the camera. Code WS040 ✗ Out-of-Stock Regular price €37.90 -€6.41 Price €31.49
Adhesive Base for Nylon Flanges This product is a 20x20mm extra strong adhesive base for nylon flanges 2.5mm up to 9mm wide. Its great fixing power prevents you from drilling. Code K0136 Available Price €0.13
Arduino Nano 33 Ble Nano was already a great invention and a super facilitator of many projects, but with Nano BLE opens yet another set of opportunities. First of all, the BLE module - the newest and lowest energy consumption connectivity solution, which effectively allows you to leverage the same technology as used in the newest mass-produced electronic devices Code BAR34 Available Price €33.99
Printed Circuit Board Terminal 2 poles 5.08mm pitch Blue 2 pole PCB mount screw terminal 5.08mm pitch Printed Circuit Board Terminal 2 poles 5.08mm pitch features: Number of Contacts: 2 Pitch: 5.08mm Number of Rows: 1 Mounting Type: PCB Gender: Male Allowable Section: 1.5mm2 (22- 14 AWG) Termination method: screw Type: screw terminal block Nominal current: 16A Nominal voltage: 250V Color: blue Material: Nylon 66 Depth: 10mm Width: 7.5mm Length: 10mm Code K0217 Available Price €0.25
Raspberry Pi 400, PC embedded in a keyboard - English Raspberry Pi 400 is the ideal tool, both educational, perfect for students of all ages, and for personal use. This RPi based on model 4, offers a low cost and portable solution, being ideal for home study and for teaching computer concepts such as programming, physical computing and networking. The Raspberry Pi 400 has a quad-core ARM Cortex A72 processor with 4GB of RAM, an Ethernet socket, 3 USB ports, two microHDMI ports and a 40-pin GPIO. English version keyboard Code RA113 ✗ Out-of-Stock Price €109.90
Seeed Grove Inventor Kit for micro:bit The Grove inventor kit is a great extension set for your micro:bit. By using Grove shield for micro:bit you are able to connect all the modules included in the pack purely by the Grove connectors with no need to solder or wire any parts. Now you can focus only on programing with your great mirco:bit. Code SS005 Available Regular price €69.90 -€20.00 Price €49.90
Raspberry Pi 5 Megapixel Camera Module The Raspberry Pi High Definition (HD) camera board connects to any Raspberry Pi or Compute Module to create HD photos and video. Code RA073 Available Price €8.95
Pimoroni Unicorn HAT HD Pimeroni Unicorn HAT HD is one of the most popular and at the same time easiest to use Raspberry HATs in Pimoroni offering. Compared to the Unicorn HAT it is equiped with twice as many LEDs in a row and a column giving a matrix of 256 LEDS! All of this accessible in a really straight forward way and supported by a range of Python libraries available on github and officially issued by Pimeroni. The hat is compatible with all Raspbery boards given its universal 40 GPIO pinout Code PI005 Last items in stock Price €49.99
T-Cobbler Protoboard Extension Plate GPIO 40 Raspberry PI B+ Pin T-Cobbler Protoboard Extension Plate GPIO 40 Raspberry PI B+ Pin features: - Shield expansion module for Raspberry Pi 2 and Pi 3, B and B + - Dimension: 6 x 7.3x 1.9mm Code RA004 Available Price €2.99
ReSpeaker 2-Mics Pi HAT ReSpeaker 2-Mics Pi HAT is a dual-microphone expansion board for Raspberry Pi designed for AI and voice applications. You can build a more powerful and flexible voice product that integrates Amazon Alexa Voice Service, Google Assistant, and so on. Code SS015 Available Price €15.90
Raspberry Pi4 4GB Basic Kit The Raspberry Pi 4 kit includes everything you need to enter the world of Raspberry Pi- all hardware in one box. plus step-by-step guide. Code RA093 ✗ Out-of-Stock Regular price €88.41 --€67.68 Price €156.09
T-Cobbler GPIO KIT + 40-pin Grey Flat Cable Pi B+ RPI 2 RPI 3 RPI Zero T-Cobbler GPIO KIT + 40-pin Grey Flat Cable Pi B+ RPI 2 RPI 3 RPI Zero features: - Shield to connect with breadboard - Dimension: 6 x 7.3x 1.9mm - Flat cable female / female 40 pins - Total length: 25cm - Quantity: 1x shield 1x flat cable Code RA010 Available Price €5.94
Pimoroni pHAT Stack - Fully Assembled Kit Can't stand to run out of pins in your Raspberry Pi? You have a cool new accessory but there's no way to plug it in? If you answered yes to any of the above, then this pHAT could be just for you. This piece has 6 sets of 40 GPIOS - one for your Pi and the rest (5) for your collection of HATs that you might want to plug in at the same time. Use it for a specific project or just to play with several HATs at once. Code PI040 Last items in stock Price €24.99
Serial Enabled 16x2 LCD - White on Black 5V It is the freshest serial LCD from SparkFun. Similarly to other SparkFun LCD screens it is put on single board with a microcontroller, however in contrast to the other screens in our offer (SP027 and SP028) it is based on PIC16F88 rather than ATmega328. Code SP035 Last items in stock Regular price €36.99 -€10.00 Price €26.99
SparkFun Pi AVR Programmer HAT - OBSOLETE You are looking for an easy way to program a microcontroller in your Arduino. It has never been easier - with this board you can do it in the record speed with support or Raspberry (or without for that matter, as the HAT works on the standalone basis as well). It was first developed as an in-house solution for Sparkfun production, and for its quality and usefulness ended up in mass production with a solid fan following. The board includes several handy features ranging from the capacitive touch button for a standalone mode to launch programming, LEDs indicating the status of the program upload as well as some whiteboard labels to keep track of your projects. Code SP0017
SparkFun Qwiic pHAT v2.0 for Raspberry Pi QWIIC is a connection standard developed by Sparkfun enabling a quick an easy connection of peripherals without a need to solder pins, without any mismatches due to polarized connector. And on top of that you can "daisy chain" them! This hat pretty much opens the whole QWIIC universe in front of your Pi. It features 4 QWIIC ports all on the same I2C bus (GND, 3.3V, SDA, and SCL). A universal 2x20 GPIO makes it compatible with all Raspberry Pi boards, as well as Google Coral and Jetson Nano. Note: For a secure connection in some applications, you'll need to add a pair of 1x20 stackable headers to extend the pins to your cart. Code SP0020 Backorder Price €7.99
M12 High Resolution Lens, 5MP, 20.2° FOV, 25mm Focal length, Compatible with Raspberry Pi High Quality Camera M12 M12 Long Focal Length Lens, 5MP, Long Focal Length 25mm, F1.7 Large Aperture, Compatible with Raspberry Pi High Quality Camera M12 Code WV014 Available Price €22.95
Pimoroni Fan SHIM Pimoroni Fan is the best you can do for your new Raspberry 4! It is a well known fact, Raspberries can get hot. Even though, there are plenty of solutions to that, you will find no better than this Pimoroni Fan. It is a no-solder device, hence you can put it on and off as you wish Code PI009 Available Price €15.99
Seeed Grove Base kit for Raspberry Pi The Grove Base Kit for Raspberry is all you need to start playing and making with your Raspberry Pi board. It is compatible with boards Pi 3 and Pi 4 and includes 8 basic sensors, a display and a motor. All of that on the grove connectors making it a seamless experience. Code SS006 Last items in stock Regular price €65.99 -€6.00 Price €59.99
Seeed Respeaker 6/Mic Circular Array Kit for Raspberry Pi With this small module, you can integrate your Raspberry with Amazon Alexa voice module or Google Assistant. It has never before been so easy. Get a chance to experience challenges of the newest technological developments in AI and smart home technologies. Code SS007 Backorder Price €59.99
Seeed Grove Inventor Kit for micro:bit The Grove inventor kit is a great extension set for your micro:bit. By using Grove shield for micro:bit you are able to connect all the modules included in the pack purely by the Grove connectors with no need to solder or wire any parts. Now you can focus only on programing with your great mirco:bit. Code SS005 Available Regular price €69.90 -€20.00 Price €49.90
Serial Enabled 16x2 LCD - White on Black 5V It is the freshest serial LCD from SparkFun. Similarly to other SparkFun LCD screens it is put on single board with a microcontroller, however in contrast to the other screens in our offer (SP027 and SP028) it is based on PIC16F88 rather than ATmega328. Code SP035 Last items in stock Regular price €36.99 -€10.00 Price €26.99
Raspberry Pi 2-3 Model B Multifunction Expansion GPIO Module This module is used to extend the Raspberry's 40 GPIO pins to another set of 2x20 male pins and 8 parallel pins accessible on the terminal blocks in the that test leads are pushed. The electronic board offers great reliability with the Raspberry and is very easy to connect thanks to its existing suitable accessories but not included. The module offers a set of mini jumpers to configure the GPIO. Code RA016 Available Price €7.95
Kit of 28 Sensors with shield for BBC micro: bit The 28 sensor kit is a great extension kit for your micro: bit. Using Sensor shield for micro: bit you can connect all the modules included in the pack only by the connectors without the need to solder or wire any part. Now you can just concentrate on programming with your big mirco: bit. Code B0076 ✗ Out-of-Stock Price €55.49