12V On/Off LED Pushbutton Green 16mm N/A NO

Ammeter 0-1 A (DC) with needle model 91C16 transparent with integrated shunt.
DC 0-1A Analog Ammeter 91C16 class 5 features:
- Model: 91C16
- Scale range: 0-1A (DC)
- Accuracy: class 5
- Transparent color
- External size: 4 x 4 x 1.1cm
- Panel size: 3.4 x 1.8 x 0.4cm
- Integrated shunt

10mm Bore Pillow Block Mounted Bearing is often suited to support rotating shaft applications.

Thermally Conductive Silicone Paste H facilitates the transfer of calories between the electronic components and the radiator.
It is necessary for the correct operation of any type of temperature sensors.

Includes a switch to output the voltage built into the case itself.
It has a cover to protect the batteries.
The cover has perforation in case you want to secure it with a screw (not included).
Battery holder 2x AA Battery holder with switch features:

- Cable 15cm long
- Measurements 68x 32x 18mm
- Battery length max 50mm
- Compatible batteries (LR06, R06, MN1500, AM3, UM3 , HP7)

Overhead power supply module with fixed 12 VDC output accepting a maximum current of 2A.
Works with frequency signals up to 1.2 MHz.
Characteristic:
- Input voltage range: 2 - 12 VDC,
- Fixed output voltage: 12 VDC,
- Output accuracy: ± 0.1 V,
- Maximum output current: 2A,
- Ripple at full load: Vpp & lt; 70mV,
- Operating temperatures: -40ºC - + 85ºC,
- PCB size: 17x13mm.

In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge.

DC 10V Analog Panel Voltmeter 0 to 10V features:
- 10V 0-10V DC analog voltage meter
- Type: Analog voltage meter
- Range of scale: DC 0-10V
- Accuracy: Class 2.5
- Complete with screws for simple DIY installation

Latching push-button 12V normally open
- For panel N / A NO 2A 36V Stainless Steel on / off
- Type of operation: On / Off
- Contact switch: 1 NA (normally open)
- Max Switch Classification: 2A / 12VDC
- Body material: Stainless steel
- Button Material: Stainless steel
- Protection Classification: IP67 / IK08
- Operating temperature: -20C + 55C
- Color: Red