Raspberry Pi 2-3 Model B Multifunction Expansion GPIO Module This module is used to extend the Raspberry's 40 GPIO pins to another set of 2x20 male pins and 8 parallel pins accessible on the terminal blocks in the that test leads are pushed. The electronic board offers great reliability with the Raspberry and is very easy to connect thanks to its existing suitable accessories but not included. The module offers a set of mini jumpers to configure the GPIO. Code RA016 Available Price €7.95
Electrolytic Capacitor 10uF 350V 105º C Electrolytic Capacitor 10uF 350V 105º C features: Code D0109 Available Price €0.39
LEONARDO R3 ATmega32u4 board + Arduino compatible USB cable It has an Atmega32u4 chip running at 16Mhz with a factory-loaded bootloader. The Leonardo module has all the connectors that the Arduino Leonardo R3 and is compatible with all Arduino shields. LEONARDO R3 ATmega32u4 board + Arduino compatible USB cable features: - ATmega32u4 microcontroller, - Operating voltage 5V, - Power (recommended) 7-12V, - Digital pins I / O 20 (of which 7 can be used as PWM outputs), - Analog input pins 12, - DC current through I / O Pin 40 mA, - DC current for pin 3.3V 50 mA, - Flash memory 32 KB (of which 4 KB are used by the bootloader), - SRAM 2.5 KB, - EEPROM 1 KB, - Clock speed 16 MHz, - Interface: UART, USB, SPI, I2C, - USB communication - Atmega32u4, Code B0004 Available Regular price €10.90 -€2.00 Price €8.90
Sensor Module Moisture Earth Water Soil The module has two outputs: analog A0 and digital D0 Digital output D0 - signal 0 appears or 1 depending on the threshold setting The threshold is set with the potentiometer The sensor can be used for example: Automatic watering for potted plants With this module you will be able to measure the humidity of the soil, so that you will be able to control the humidity level of the soil of your plants Characteristic: Operation: 3.3V -5V - Sensitivity adjustable by potentiometer - Dual output mode: analog and digital - Red LED - power indicator - Green LED - indicator digital switching output - PCB measurements: 3 x 1.5 cm - Probe measurements: 6 x 3 cm Code S0021 Available Price €1.95
Prototype Board MB102 Protoboard 830 points for Arduino Prototype Board MB-102 Protoboard 830 points Arduino features: - 830 Connections - Linkable with other boards - Base with adhesive to attach it to the work surface - Measures 165x 55x8mm Code PB004 Available Regular price €2.99 -€0.50 Price €2.49
Relay Module DC 12V 10A 1 Channel Low/High Trigger Relay Module DC 12V 10A 1 Channel Low/High Trigger features:- Channel: 1 (protected with Optocoupler)- Supply voltage: 12V- Output Current: 10A- Relay activation current: 15mA ~ 20mA- Insulation: Yes- Trigger signal type jumper (low / high)- LED indicator- Dimensions: 30x 54mm- Has a jumper that allows to choose type of trigger signal (low / high) Code RL003 Available Price €2.29
Pulley GT2 16 Teeth 6mm Aluminium Pulley 3D Printer Reprap Pulley GT2 16 Teeth 6mm Aluminium Pulley 3D Printer Reprap features: - Number of teeth: 16 - Pitch: 2mm - Material: aluminum alloy - Outside diameter: 13mm - Inner hole: 5mm - Use with strap: 6mm - Quantity: 1 unit of 16 teeth GT2 pulley, 6mm wide and 2 studs - Ideal for fix on the axis of the motors of your 3D printer Code I0004 Backorder Regular price €1.94 -€0.50 Price €1.44
Continous Rotation 360 Degree Servo S3003 Continous Rotation 360 Degree Servo S3003 features: - Operating voltage: 4.8 V to 6 V- Torque max.: 4.1kg / cm (6V)- Operating speed: 0.23sec / 60degree (4.8V), 0.19sec / 60degree (6V)- Radio max.: 360º- Temperature range: -20º + 60ºC degrees- Weight: 38 g- Cable length: 26cm- Dimensions: 40.5 x39x 20 mm- Servo connector: JR- Chinese manufacture Code R0019 Available Regular price €7.95 -€0.96 Price €6.99
Rocker switch KCD4 momentary 15A 250V Double (ON)-OFF Red The AC 250V 15A 6-pin DPST (on)/off type rocker switch. Code K0402 Available Price €1.90
5x Push Switch Button B3F Omron Red Key 12mm 5x Push Switch Button B3F Omron Red Key 12mm features:- 5x Push Buttons B3F Omron Key- Maximum current: 50 mA- Tension DC: 24V- Operating force: 1.27N- Switch terminals: weldable- Contact: SPST-NO- Contact resistance: 100M Ohm- Type of action: Superficial- Measures: 12x12x7.3mm Code K0073 Available Price €0.20
Limit Switch with Wheel - 5A 250 Vac - 1 switched - Arduino compatible Limit Switch with Wheel - 5A 250 Vac - 1 switched - Arduino features: -Micro KW12-3 on / off switch -Max Current: 5A -AC voltage: 125-250V -Operating temperature: -40 to 70 degrees C -Quantity: 2 units Code K0018 Available Price €0.59
Push button 6x6x4mm Push button 6x6x4mm features: -Touch Push Tact Switch mini electronic Arduino push button -Measures: 6x6x4.3mm -Quantity: 1 unit Code K0201 Available Price €0.21
10x Tactile Tact Push Button Switch 6x6x8mm 10x Tactile Tact Push Button Switch 6x6x8mm features:- Tactile Push Tact Switch mini electronic Arduino pushbutton- Measures: 6x6x8mm- Quantity: 10 units Code K0076 Available Price €0.15
Momentary Switch Push Button Red N/O 7mm Momentary Switch Push Button Red N/O 7mm features: - Momentary pushbutton N/O (normally open)- Red button- Dimensions approx. 7 mm x 27 mm- Recessed with nut and washer- Load current (supported): 1A to 230V / 2A to 125V- Drill to embed: 7 mm +/- 0.2- Operating temperature: -55º to +85ºC Code K0156 Available Price €0.45
12V Momentary LED Pushbutton Blue 16mm N/A NO 12V Momentary LED Pushbutton Blue 16mm N/A NO features:- Type of operation: momentary (automatic return)- Contact switch: 1 NA (normally open)- Max Switch Classification: 2A / 12VDC- Body material: Stainless steel- Button Material: Stainless steel- Protection Classification: IP67 / IK08- Operating temperature: -20C + 55C- Color: Blue Code K0099 Available Price €5.89
Monostable push button 3A 250V AC / 5A 30V DC, Illuminated 230V Momentary push button, illuminated, round AC 250V 3A / 5A 30V DC 5-pin. Light source: LED. Backlight supply voltage 230V. Push button screwed to housing, panel mounting. Code K0404 Available Price €2.95
12V Momentary LED Push Button Switch White 16mm N/A NO 12V Momentary LED Push Button Switch White 16mm N/A NO features: - Type of operation: Momentary (automatic return)- Contact switch: 1 NA (normally open)- Max Switch Classification: 2A / 12VDC- Body material: Stainless steel- Button Material: Stainless steel- Protection Classification: IP67 / IK08- Operating temperature: -20C+ Code K0098 Available Price €5.89
Vertical Slide Switch 2P2T 50V 0.5A 6 DIP pins and 2 positions DPDT. This switch is widely used to control the operation of many small electronic power projects, including volume and other controls for audio video, dimmer controls for lights.It is also a great component for DIY. Vertical Slide Switch 2P2T 50V 0.5A features: - Type: 2P2T- Contact resistance: 30 MΩ max.- Insulation resistance: 100 MΩ- Maximum operating voltage: 50V- Maximum operating current: 0.5A- Can support 500 VAC for 1 minute- Step between pins: 2.54mm / 0.1 "- Pin size: 4.5x0.5x15 / 0.77 "x0.19"- Type of current: DC- Pins to be welded- Switch action: 2 ON / OFF positions- Shape of interrupter: rectangular- Size: 16x6.5x15 / 0.2 "x0.02" Code K0104 Available Price €0.49
Push button 6x6x5mm 2pins Push button 6x6x4mm features: -Touch Push Tact Switch mini electronic Arduino push button -Measures: 6x6x45mm -Quantity: 1 unit Code K0269 Available Price €0.24
12V On/Off LED Pushbutton Green 16mm N/A NO Characteristic:- For panel N / A NO 2A 36V Stainless Steel on / off- Type of operation: On / Off- Contact switch: 1 NA (normally open)- Max Switch Classification: 2A / 12VDC- Body material: Stainless steel- Button Material: Stainless steel- Protection Classification: IP67 / IK08- Operating temperature: -20C + 55C- Color: Green Code K0193 Last items in stock Price €5.89
DIP Switch - DS-04 Horizontal High Profile 4 Positions The DIP switch type THT (4 rows 8 Pins) with a pitch of 2.54mm / 0.1 ". It works with the current of 50mA DC 12V. Code K0264 Available Price €0.79
5x Push Switch Button B3F Omron Red Key 12mm 5x Push Switch Button B3F Omron Red Key 12mm features:- 5x Push Buttons B3F Omron Key- Maximum current: 50 mA- Tension DC: 24V- Operating force: 1.27N- Switch terminals: weldable- Contact: SPST-NO- Contact resistance: 100M Ohm- Type of action: Superficial- Measures: 12x12x7.3mm Code K0073 Available Price €0.20
DIP Switch - DS-02 Horizontal High Profile 2 Position The DIP switch type THT (2 rows 2 Pins) with a pitch of 2.54mm / 0.1 ". It works with the current of 50mA DC 12V. Code K0262 Available Price €0.43
DIP Switch - DS-01 Horizontal High Profile 1 Position The DIP switch type THT (1 row 2 Pins) with a pitch of 2.54mm / 0.1 ". It works with the current of 50mA DC 12V. Code K0261 Available Price €0.35
12V Momentary LED Push Button Switch White 16mm N/A NO 12V Momentary LED Push Button Switch White 16mm N/A NO features: - Type of operation: Momentary (automatic return)- Contact switch: 1 NA (normally open)- Max Switch Classification: 2A / 12VDC- Body material: Stainless steel- Button Material: Stainless steel- Protection Classification: IP67 / IK08- Operating temperature: -20C+ Code K0098 Available Price €5.89
10x Tactile Tact Push Button Switch 6x6x8mm 10x Tactile Tact Push Button Switch 6x6x8mm features:- Tactile Push Tact Switch mini electronic Arduino pushbutton- Measures: 6x6x8mm- Quantity: 10 units Code K0076 Available Price €0.15
Momentary Switch Push Button Red N/O 7mm Momentary Switch Push Button Red N/O 7mm features: - Momentary pushbutton N/O (normally open)- Red button- Dimensions approx. 7 mm x 27 mm- Recessed with nut and washer- Load current (supported): 1A to 230V / 2A to 125V- Drill to embed: 7 mm +/- 0.2- Operating temperature: -55º to +85ºC Code K0156 Available Price €0.45
Switch On/On 3-pin 6A SPDT This switch can be used for development projects and for the industry. All metal parts are not oxidized, the insulation material is of high quality.Its pins protected by an anti oxidant makes welding much easier. Switch On/On 3-pin 6A SPDT features: - Type: Latch SPDT- Material: Plastic, metal- Maximum operating current and voltage: 3A / 250V, 6A / 125V- Number of pins: 3- Pin size: 4.5x2 mm- Type of current: AC/DC- Pins to be welded- Switch action: 2 positions On/On- Size: 13.2x12.7x33.3mm Code K0420 Available Price €0.49