Bridge Rectifier DB107 1A / 1000V DIP4

LED Display Screen Board Matrix 8x8 Common Anode/ Common Cathode Columns Red Dots features:
- Supply voltage of the LED points: 1.8-2.4 VDC
- LED color of the dots: red
- Pin numbers: 16
- Diameter of pins: 0.51mm
- Step between pins: 2.54mm
- Consumption current per segment: 30mA
- Maximum admissible current per segment: 120mA
- Power consumed per segment: 80mW
- Segment numbers (points): 64
- Diameter of a point: 3mm
- Operating temperature: -35°C - + 85°C
- Storage temperature: -35°C - + 85°C
- Screen with common anode connection for the rows and common cathode for the columns
- Screen size: 32x32x8 mm

The 28BYJ-48 has everything you need to start using stepper motors in your project
A stepper motor converts digital impulses into small steps of movement in one direction The engine also comes with a ULN2003 engine controller card
Can control two DC motors or a bipolar stepper motor with a maximum amperage of up to 500 mA
Equipped with state indicator LEDs A, B, C, D 5V Stepper Motor 28BYJ-48 + ULN2003 Driver Boat features:
- Engine model: 28BYJ-48
- Phases engine: 4
- Operating voltage: 5V
- Frequency: 100 Hz
- Operating current: 200mA
- Max Power: 20W
- Winding resistance: 70 ohm
- Angle per step: 5,625º
- Steps per round: 64
- Torque: 0.3 Kgr / cm
- Speed: 1900 rpm

It is used to pass the current, power electrical and electronic circuits, fans, motors, among others. Banana Black Connector Type II ZL15 features:

For Arduino, Smart Car, Robotics.
Small electric motor magnet for direct current (DC). Micro Motor 3V 5V 6V DC DIY Arduino UNO Mega Robotics features:
- Operating voltage: 1.5V to 6V
- DC current: 350mA
- Torque max.: 15g / cm
- Max speed: 12000rpm
- Weight: 16.5 g

Resistor 1M Ohm 5% 0,25W 1/4W features:
-1M Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Protection box for Arduino UNO R3 made of high quality acrylic material. Arduino Uno Transparent Acrylic Box R3 features:
- Compatible with Arduino UNO
- Material: transparent acrylic
- External dimensions: 80x 65x 18.5mm

2 Channel Relay Module 5V 10A for Arduino features:
- 5V relay module with 2 optocoupled channels
- This module can be controlled directly by the microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL)
- Channels: 2 (independent protected with Optocouplers)
- Supply voltage: 5V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- LED indicator: For each channel
- Dimensions: 40x 50mm