2x Electronic Clips Crocodile 2x50mm Black + Red pack 2pcs

10x Female-Male Cables 20cm Jumpers Dupont features:
-Length: 20cm
-Quantity: 10 cables
-Connectors have male and female header contacts at either end
-Compatible with male and female connectors 2,54mm
-High quality and good working conditions
-Easy to install and use

PCB Circuit Board Marker Pen 1.0mm for printed circuits features:
-Permanent resistance ink to acid attack
-Ideal to write on almost any flat surface, such as PCBs, glass, plastic, metal, etc.
-Does not leave stains of ink, resistant to sunlight
-Quantity: 1.00mm - 1 unit

Thermally Conductive Silicone Paste H facilitates the transfer of heat between the electronic components and the radiator. It is necessary for the correct operation of any type of temperature sensors. Global coefficient of heat transfer at 0-150 ° C: 0.88 W / m K

Electronic Prototype ABS Plastic Black Box 100x60x25 features:
- Box for electronic projects, power supply units, student projects,
amplifiers, etc
- Dimension 100x60x25 mm

WIFI transceiver based on the ESP8266 controller.
It has a microcontroller and 2 GPIO pins to be able to operate autonomously without the need for an external microcontroller. Characteristic: - Voltage of power: 3.3V
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz
- Band: 2400 (MHz)
- Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and integrated power management units
- Output power: 0.15 (W); + 19.5dBm in 802.11b mode
- Consumption in low power mode:

For Arduino, Smart Car, Robotics.
Small electric motor magnet for direct current (DC). Micro Motor 3V 5V 6V DC with cable conector male features:
- Operating voltage: 1.5V to 6V - Cable 16cm with male connector - DC current: 350mA - Torque max.: 15g / cm
- Max speed: 12000rpm
- Weight: 16.5 g

The DIP switch type THT (4 rows 8 Pins) with a pitch of 2.54mm / 0.1 ". It works with the current of 50mA DC 12V.

A preparation to remove oxides and sulphites from electrical contacts and to provide protection against corrosion, ensures the flow of electricity especially in case of rusty or worn contacts.
It can be used in audio products - low frequency and high, electronic industry and in other places where clean contacts are required.
For cleaning contacts, electrical terminals, alternators, switches, plugs, sockets integrated circuits, lampholders, fuseholders, capacitor contacts, flowmeters etc. 400ml Electrical Contacts Cleaner Spray + Brush features:
- Restores low resistance in connections
- Used in audio technologies
- Protection against moisture and corrosion
- High quality - manufactured in EU