Battery holder 1x 18650 3.7V Power cable

Sonoff 433 MHz wireless remote control 4 buttons (IM160323001) This product can work with our smart home products: SONOFF RFR2, SONOFF SlampherR2, SONOFF 4CHPROR3, SONOFF RF Bridge 433, SONOFF TX.

Screen OLED 0.96" 128x64 White SPI I2C 7 Pin features:
- Oled 0.96 "screen with 128 * 64 pixels
- Drive IC model SDD1306
- Power: 3V-5.5V - Viewing angle: 160 degrees
- SPI interface (I2C can be changed)
- Low consumption: 0.08W
- Operating temperature: -20 to 70 ºC
- PCB board dimension: 27 x 27mm
- Supports many control chip: 51 Series, MSP430 Series, STM32 / 2, CSR IC, etc.
- OLED technology offers high contrast, significantly improves black on screen energy efficiency - very low power consumption Applications: - Due to the size, quality and consumption of smart watch products, portable meters , medical devices, portable players, etc.

Momentary Switch Push Button Red N/O 7mm features:
- Momentary pushbutton N/O (normally open)
- Red button
- Dimensions approx. 7 mm x 27 mm
- Recessed with nut and washer
- Load current (supported): 1A to 230V / 2A to 125V
- Drill to embed: 7 mm +/- 0.2
- Operating temperature: -55º to +85ºC

Premium Bobina para Impresora 3D

Wired Bone Conductor Transducer - 8 Ohm 1 Watt
This amazing speaker does not have a movable cone like most From the speakers you've seen, instead, a small metal rod is wrapped with the voice coil.
When the current is driven through the coil, the magnetic field makes a piece of metal expands and contracts, if pressed against a flat surface or cavity makes it a speaker! Often these size transducers are pressed against the jaw or ear bone to turn the skull into a speaker socket.
The effect is a perfect quality sound that comes from your head and no one else can hear it. You can also press it against your elbow bone and stick a finger in your ear to listen to the audio transmitted through your arm!

Switch Button 8x8mm on-off features:
- Switch terminals: Weldable
- Measures: 8x8x13mm

Rechargeable Battery XTAR 18650 2600mAh Li-ion features:
- With PCB protection circuit that protects the battery against overcharges and over-discharges, increasing battery life
- Quantity: 1 unit

Heat Shrinkable Tube 5 Colors 3 Meters Package features:
- Heat shrink tubing is used to connect electrical cables, isolate resistor and capacitor points, mark and protect cables Electrical, protect metal bars or tubes against corrosion and protect antennas.
- These heat shrink tubes are very flexible and of high quality. Made in EU
- Different sizes of 20 cm each are delivered:
* 1,6mm: black, brown, red, yellow, orange
* 2,4mm: black, brown , red, yellow, blue
* 3,2mm: black, brown, red, yellow, blue
- Quantity: 15 units
- Material: polyolefin
- Shrinkage ratio: 2: 1 (maximum reduce to 1/2 of its supplied diameter)
- Minimum shrinkage temperature: 115 ° C maximum 200 ° C