Lithium Battery Holder Button 3V CR1220 SMD PCB

Module for Arduino, Raspberry Pi 2 and Pi 3, B and B +.
The display module 4-digit LED with TM1637.
The unit can be controlled with just two DIO and CLK control lines.
TM1637 4-Digit Digital Display Module features:

- 3V-5V supply voltage
- Current consumption 250 mA
- 7-segment display 4 digits common anode
- Digit size: 0.36 inches
- Dimensions: 42x24x11mm

3V CR1220 button lithium battery features:
- 3V battery
- Diameter: 12.5mm
- Voltage: 3V
- Capacity: 45mAh
- Quantity: 1 unit

It has an ATMega328P chip running at 16Mhz with a factory loaded bootloader
Characteristic:
- Microcontroller: ATmega328
- Operating Voltage (logic level): 5V
- Input Voltage (recommended): 7-12V
- Digital I / O Pins: 14 (6 PWM outputs)
- Analog Inputs: 8 (A0-A7)
- DC Current per Pin I / O 40 mA
- Flash Memory: 32 KB (2 KB used by the bootloader)
- SRAM: 2 KB
- EEPROM: 1 KB
- Clock Frequency: 16 MHz
- USB Communication - CH340
- Dimensions: 18 mm x 44 mm

It has an Atmega2560 chip running at 16Mhz with a factory loaded bootloader with 54 digital input / output pins (from which 14 can be used as PWM outputs) and 16 analog inputs, 4 UART (hardware serial ports). The board includes a USB connector, an ICSP port, a reset button and some status LEDs. Atmega16U2 programmed as a USB-to-serial converter. Simply connect it to a computer with a USB cable or power with a power adapter and DC connector.

10x Push button 6x6x9mm features:
-Touch Push Tact Switch mini electronic Arduino push button
-Measures: 6x6x9mm
-Quantity: 10 units

Push button 6x6x4mm features:
-Touch Push Tact Switch mini electronic Arduino push button
-Measures: 6x6x4.3mm
-Quantity: 1 unit