JST PHR-2 Female 2 PIN 2mm

Insulated connectors set 175 pcs. 18 types
Set of insulated connectors 175 units 18 types features:
Dimensions of the plastic box:
- Width: 280 mm
- Depth: 185 mm
- Height: 42 mm
Technical data of the connectors:
- Material: tinned steel
- Insulation: PVC

It allows controlling up to 2 direct current motors or a bipolar stepper motor. It also allows to control a unipolar stepper motor configured as bipolar.
Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32.
It incorporates a switch for the connection and disconnection of the entire module.
L298N Motor Drive Controller Board Module Dual H Bridge DC with interruptor features:
- Minimum operating voltage: 5 V
- Maximum operating voltage: 35 V
- Maximum current: ± 2 A
- Logic voltage: 5V
- PWM signal inputs for speed control
- Outputs: for 2 DC motors or for a bipolar stepper motor
- Measures: 43x43x24 mm
Helpful Links:
Operation of the robot by Infrared / Operation of the robot by Bluetooth />

5x Female Strip 20 Short Pins features:
- Pin spacing: 2.54mm
- Insert position: Vertical
- Insert: Pasante
- Quantity: 5 units of strips of 20 female pins each

Double Cable 26AWG Red Black Flexible PVC - 0,13mm² Prototype features:
- Ideal for your electronic projects.
- Length: 1m
- Conductor: flexible copper
- Insulation: PVC
- Low voltage electric cables
- Cable type: 26AWG
- Resistance to 20ºC: 133.9 Ohm / Km
- Diameter: 0.40mm

USB Connector, Shielded, Micro USB Type B, USB 2.0, Receiver, 5 Way, Surface Mount features:
- Application: for mounting on PCB boards,
- Signal contacts 1.0A,
- Contacts power 1.8A,
- Maximum supported voltage: 30 VAC (RMS)
- Component type: USB 2.0 Micro-B receptacle
- Color: gray,
- Female connector,
- Nailed to mating part: yes,
- Locking to mating part: no,
- Connector material: Copper and metal alloy,
- Material of Pins: Gold Alloy,
- Orientation: Right Angle,
- PCB Retention: None,
- Pitch - Mating Interface: 0.65mm,
- Pitch - termination interface: 0.65mm,
- Port: 1,
- Surface Mount Compatible (SMC): yes,

Thermal transfer paper enables PCB manufacturing.
After designing the printed circuit in one of many programs, you must print the project on paper on a slippery page (in the reflected image) with a laser printer. The pattern (printed side) is transferred to the laminated plate from the copper side using the hot iron (the toner adheres to the copper under the influence of temperature).
It remains only to peel off the paper under water and start to engrave the laminate. It can be attacked with the Printed Circuit Recorder solution A4 Thermal Transfer Film for DIY PCB circuits features:

- material: A4 thermal transfer foil - quantity: 1 sheet

  IP65 waterproof case ideal for electronic projects, energy supplies, student projects, amplifiers.   Electronic waterproof plastic cover features:
  - Material: extruded plastic,
- Waterproof protective indication: IP65,
- Includes 4 screws and waterproof assembly,
- Size external: 158x90x60mm, - Dimension internal: 158x90x60mm,
- Weight: approx. 190g