Cutting Pliers 130mm

Soldering tip cleaner allows removing the solder residues from the tips.
It cleans better and does not cause temperature drops like with sponges.
You do not need extra water to clean the tip.
Easy and effective cleaning at the tip.

A preparation to remove oxides and sulphites from electrical contacts and to provide protection against corrosion, ensures the flow of electricity especially in case of rusty or worn contacts.
It can be used in audio products - low frequency and high, electronic industry and in other places where clean contacts are required.
For cleaning contacts, electrical terminals, alternators, switches, plugs, sockets integrated circuits, lampholders, fuseholders, capacitor contacts, flowmeters etc. 400ml Electrical Contacts Cleaner Spray + Brush features:
- Restores low resistance in connections
- Used in audio technologies
- Protection against moisture and corrosion
- High quality - manufactured in EU

Fan 12V 2x Cable 50x50x15 3D Printer Reprap features:
- Voltage: 12V
- Speed: 7000rpm ± 10%
- Screw diameter: 4.5mm
- Time lifespan: 50,000 hours
- Operating temperature: -10 ° C to 70 ° C
- Cable length: 28cm
- Dimensions: 50mm x 50mm x 10mm

This small GPS module is an ideal module for Arduino. The NEO-7 series is characterised by the exceptional performance of the highly sensitive u-blox 7 GNSS (GPS, GLONASS, QZSS and SBAS).

Red Laser Cross Module 650nm 5mW Head Point Adjustable Focal Length features:
- Type: red laser diode
- Type of laser: cross
- Adjustable Focus
- Wavelength: 650nm
- Output power: 5mW
- Operating voltage: 4.5-5V
- Operating intensity: <40mA
- Operating temperature: -30ºC to 60ºC
- Dimensions of the emitter: Φ12x35mm
- Cable length: 130mm

It can be used to demagnetize tools or parts that you do not want to magnetize. Especially for magnetizing screwdriver bits or almost anything else. No batteries or electricity required, portable and easy to use.

RepRap Arduino Mega Pololu Shield (RAMPS) version 1.5 for 3D printer. Includes jumpers.

RAMPS plate is a shield for the Arduino Mega2560. The outputs of the Arduino board are redirected to the motor drivers. To have the complete electronics for a 3D printer you need a RAMPS, an Arduino Mega and at least four stepper motor drivers A4988, DRV8825.

40x Female-Female Cable 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Dupont female connectors on both ends
- Compatible with 2.54mm male connectors
- High quality and good working conditions
- Easy to install and use