Mounting Bracket for Nema Motor 23 57mm/76mm

Limit Switch with Wheel - 5A 250 Vac - 1 switched - Arduino features:
-Micro KW12-3 on / off switch
-Max Current: 5A -AC voltage: 125-250V
-Operating temperature: -40 to 70 degrees C
-Quantity: 2 units

It has an automatic voltage regulator, which for practical purposes results in quieter operation and less vibrations.
Characteristic:
- Minimum operating voltage: 8 V
- Maximum operating voltage: 45 V
- Maximum current: ± 2.5 A (24V, adequately ventilated or refrigerated)
- Logic voltage: 3 V / 5.5V
- Microstep resolution: full, 1/2, 1/4, 1/8 , 1/16, 1/32
- Factory soldered temples
- 4-layer PCB, 2 oz. Copper for improved heat dissipation
- Short-circuit and overtemperature protection - Use potentiometer to adjust the current
- Measurements: 20x16x12 mm

Tin ideal for application in consumer electronics circuits
Tin Roll 60/40 Sn/Pb 2.5% Flux 10g 1mm features:
- 16 gr. welding wire of 1 mm diameter. 60% tin, 40% lead
- Melting temperature 187/190 C
- Alloy Sn60Pb40
- Flux 2.5% SW26 1.1.2B ISO9454 - It is leaded alloy for manual and automatic processes where meeting the requirements of the RoHS2 Directive is not required.  - Quantity: 1 unit
- High quality - manufactured in EU

Descent module.
Use a multimeter to check the output voltage and adjust the potentiometer.
Control of tension.
LM2596 DC Voltmeter Converter 3A Step Down Adjustable Power features:
- Input voltage: 4.5-38V
- Output voltage: 1.25-36.5V
- Current output: 2A (max 3A with heat sink)
- Operating temperature: -40 to + 85 ºC
- Operating frequency: 150KHz
- Efficiency conversion: up to 92%
- Load Regulation: +/- 0.5%
- Voltage Regulation: +/- 2.5%
- Protection over temperature: the output switches off automatically
- Size: 62mm x 38mm x 15mm
Principal functions:
- Step-down converter with overcurrent protection
- Voltmeter up to 40V, remember to set the input voltage to 4.5V

Battery charger for 12V gel batteries with battery state of charge monitoring. Alligator clip connectors.

40x Female-Female Cable 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Dupont female connectors on both ends
- Compatible with 2.54mm male connectors
- High quality and good working conditions
- Easy to install and use

It is compatible with almost any microcontroller, Arduino, PIC, AVR.
It can be used in Access Control projects and Alarm projects. RFID Module with Card and Pendant features:
- Supports Quick CRYPTO1 and MIFARE
- Operating current: 13-26mA at 3.3V
- Standby current: 10-13mA to 3.3V
- Sleep-mode current: <80μA
- Maximum current: 30mA
- Frequency of operation: 13.56Mhz
- Reading distance: 0 to 60mm
- Communication protocol: SPI
- Maximum SPI speed: 10Mbit / s
- Maximum data rate: 10Mbit / s
- Operating temperature: -20 to 80ºC
- Humidity of operation: 5% -95%