Micro Bits for 3D Printer Nozzle pack 10pcs

Heatsink aluminium adhesive radiator for electronics components. Especially recomanded for passive cooling of Stepper Drive, MOSFET, VRM, Vram, IC Chips etc.

Good thermal conductivity, reduce the risk of hardware failure due to overheating, made of high quality Aluminum.

It can be used to control the microprocessor of the Arduino AVR PIC system and others, or as a digital potentiometer rotating the rotary encoder can be counted in positive and negative, depending on the direction of rotation; with the button of the rotary encoder can be reset to its initial state, which starts counting from 0.

ESP32 processor development board with WiFi and Bluetooth (BLE) compatible with Arduino Uno shields. It is much faster than the ESP8266 processor (NodeMCU and the like) . Wemos D1 ESP32 R32 WROOM-32 WiFi and Bluetooth features:
Power: 5-12VDC WiFi 802.11 b / g / n / e / i (802.11n up to 150 Mbps) Bluetooth v4.2 BR / EDR and BLE. Compatible with Arduino Uno shields. 6 Analog input. 20 digital inputs / outputs (3.3V) (with PWM functions, interrupt). UART, SPI, I2C communication. Size: 68Ã — 53 mm Micro USB connection. 4Mbytes Flash Memory 520Kb Clock: 240Mhz (a core dedicated to WiFi processing) Temperature: -40C + 85C Current: 250mA (max) Current in saving mode: 0.15mA Operating current: 20mA (without WiFi) Useful links for Arduino / Raspberry programming and projects with Arduino /

Nozzle Head 0.4mm 1.75 E3D 3D Printer features:
- Precision Nozzle: 0.4mm
- Material: Copper
- Size: 13mm x 6mm - Suitable for Filament: 1.75mm
- Quantity: 1 unit

Dupont Connector 2.54mm Male features:
- Connector for soldering or crimping
- Lot 100 units
- Ideal for your projects electronic, arduino, but can also be used with other microcontrollers

ST-LINK V2 Debugger / chip programmer for STM8 and STM32, supports SWIM and JTAG Serial Wire interfaces.

Black U-shaped servo motor mounting bracket for MG995 and MG996 servo motors. Ideal for robot arms or creating your own structures. Includes hardware.

The module uses a 24-bit high precision A/D conversion chip HX711.
The input circuit can be configured to provide a bridge.
The electric bridge voltage sensor model (such as pressure, weight) is an ideal sampling module with high precision and low cost. HX711 Module Weighing Pressure Sensor 24 Bits features:
- Two selectable differential input channels
- Active low noise PGA with selectable gain of 32, 64 and 128
- Power supply regulator for load cell and ADC analog power supply
- Oscillator on chip that does not require external component with optional external glass
- Power-on-reset on the chip
- Simple serial control and serial interface: controls driven by pins, programming is not required
- Output data rate 10SPS or 80SPS selectable