2x Insulation Tapes PVC Green 10m x 15mm x 0.13mm

Descripción: Light sensor module to measure light intensity and obtain digital data from it.
Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32.
BH1750FVI (Rohm) is used to adjust backlighting of LCD screens and keyboards by manufacturers of mobile phones, digital cameras, navigation and portable gaming devices. Light Sensor Module BH1750 FVI Arduino Raspberry features:
- Chip BH1750FVI
- Supply voltage 3V-5V
- Integrated 16bit AD converter
- Detection range: 0-65535 lx (with an accuracy of 1 lux)
- Interface: II2C
- Low dependence on the light source (eg incandescent lamp, fluorescent lamp, halogen lamp, white LED, sunlight)
- Dimensions 18.4 x 14 mm

40x Male to male cables 10cm features:
- Length: 10cm
- Quantity: 40 cables
- Dupont male connectors on both ends
- Compatible with 2.54mm female connectors
- High quality and good working condition
- Easy to install and use

- It has an Atmega328P chip running at 16Mhz with a factory loaded bootloader - The Uno R3 module has all the connectors than the Arduino Uno R3 and is compatible with all Arduino shields Arduino compatible UNO R3 board features:
- Includes USB Cable - ATmega328P 16MHz chip with external quartz crystal
- Microprocessor: ATmega328
- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Input voltage (limits): 6-20V
- Clock speed: 16 MHz
- Digital I / O Pins: 14
- Analog input pins: 6
- DC current per I / O Pin: 40 mA
- DC Current per Pin 3.3V: 50 mA
- Flash32 KB of which 0.5 KB are used by the bootloader - Atmega328
- SRAM 2 KB - Atmega328

Low Signal High Speed ​​Switching.
These diodes are widely used to multiplex signals, such as buttons or digital inputs Characteristic:
- Reverse voltage: 100V,
- Forward voltage drop: 1V to 10mA,
- Forward direct current: 200mA,
- Maximum overvoltage current: 4A,
- Dissipated power: 500mW,
- Recovery time: 4ns,
- Configuration: Simple,
- Package: DO-35,
- Quantity: 30 units .

Characteristic: - Solder paste according to DIN EN 29454-1 1.1.2.C.
- Flux paste based on activity rosin medium.
- Easy to weld: copper, silver, zinc and nickel plated. Flux residues after soldering do not cause corrosion of non-ferrous metals and can remain in the joints .
Operating temperature up to 350 C.

Characteristic:
-10k OHM kΩ - linear potentiometer 10k Arduino
-Tolerance: +/- 20%
- Power: 0.125W

Ideal to control the speed of DC motors.
Characteristic:
- Input voltage: 12-40VDC,
- Max continuous output current: 8A (peak current 10A),
- Control power: 0.01- 400W,
- Dimensions: 60x75x28mm,
- PWM frequency: 13kHz,
- Static current: 0.02 A (Standby),
- Adjustable duty cycle: 10% -100% ,
- It integrates a L7812CV TO-220 regulator,
- It incorporates a 10A fuse to protect the power circuit.
Note that the voltage applied to the motor will be the supply voltage applied to the circuit.