2x Insulation Tapes PVC Black 10m x 15mm x 0.13mm

Cutting Pliers 130mm features:
- This model is not isolated, please use it without current
- Use to cut soft materials, electronic components, cables, plastic card
- Can also be used for welding work

IR Remote Control + IR Infrared Receiver VS1838 features:
- The test distance is about 5-8 meters, but practical application depends on environmental factors (such as diaphragm, glass , obstructions or other material blockage) - The CHQ1838 / HX1838 receiver receives the 38kHz signal
- Vcc supply: 3.3V-5V
- IN digital output to connect to the port Arduino I / O
- Remote measurements 85x 40x 5mm
- Includes battery
Useful links for Arduino / Raspberry programming and projects with Arduino boards / Raspberry:
Send / Receive information via IR
- Wiring of the IR Remote control + Infrared IR Receiver VS1838 with the UNO module
- Light a 3mm red LED by Infrared

Characteristic: -Low voltage electric cables
-Normal: EN 50525-2-31
-Number of conductors: 1x1.50mm2
-Service voltage: 450 / 750V
-Service temperature: at 70ºC
-Resistance at 20ºC: 13.3 Ohm / Km
-Weight (Kg / Km): 21
-External diameter: 3.4mm

-Length 1m

Version compatible with Arduino Mega2560 R3
It has an Atmega2560 chip running at 16Mhz with a factory-loaded bootloader
With 54 digital input / output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UART (hardware serial ports)
The board includes a USB connector, an ICSP port , a reset button and some status LEDs
Arduino compatible Mega2560 R3 CH340 board features:

- Operating voltage: 5V
- Input voltage (recommended): 7-12V
- Digital I / O Pins: 54 (14 PWM outputs)
- Analog input pins 16
- DC current per I / O Pin 40 mA
- DC Current per Pin 3.3V 50 mA
- Flash: 256 KB of which 8 KB are used by the bootloader
- SRAM: 8 KB
- EEPROM: 4 KB - Clock speed 16 MHz

Ceramic Capacitor 100nF (0,1uF) 50v 104 PCB PIC Arduino features:

Orders only in multiples of 20 units
-Type: Ceramic Y5V
-Tolerance: +80/-20%
-Dimensions: diameter 9.5mm, pitch 5.08mm

Desoldering iron for the removal of excess tin. You can quickly and effectively remove solder from a plate or circuit.
Replaceable antistatic nozzle.
Manufactured in Aluminum.
Aluminum Desoldering Pump Tin Antistatic Suction features:
- Length: 190mm
- Desoldering pump
- High suction power
- Replaceable long-life silicone tip
- Light weight
- Easy use with one hand, light and resistant
- Vacuum Solder Aluminum Desoldering Pump Solder Remover Pump Tool
- A good quality product for fast and efficient removal of excess solder, ideal for PCB repair
- High-capacity spring-loaded plunger quickly eliminates welding in one action. The Pumping tool easily
- Disassemble for a quick clean

A high-performance regulator-booster.
24V battery charger - DC / CV method.
Power supply of the laptop from a 12V car battery.
A high-performance dimmer-regulator.
Charger for Li-Ion, Li-Po batteries etc. - CC / CV method.
LED Constant current driver for LED diodes.
Characteristic:
- Input voltage: 6V -40V
- Output voltage: 1.25-35V (adjustable)
- Output current: 8A, (10A maximum)
- Output power: 300W maximum
- Efficiency of Conversion: up to 95%
- Wiring: Solderless terminal
- Operating frequency: 300kHz
- Ambient temperature exceeds 40 ° C, increase heat dissipation
- LED indicator two-color;
- Charge red
- Fully charged light green
- No charge green

Flux Colophony Rosin Core 40g features:
Flux rosin, solid resin, neutral ph for a correct electronic welding.
- They do not cause corrosion of non-ferrous metals
- Does not cause short circuits
It melts with the temperature, spreading through the area to be welded and penetrating into the most difficult corners, cleans and prepares the surfaces and components to be welded, and facilitates the adhesion and fluidity of the tin, improving welding in electronics works.
Use a toothpick for the application. Do not apply in excess.
Security:
- Use in ventilated spaces. Do not inhale vapors that are released when welding
- Keep the pot tightly closed and out of the reach of children
- Do not eat. It is not toxic
- Rarely irritating to skin contact