non-contact voltage detector - Fazer 777
  • non-contact voltage detector - Fazer 777
  • non-contact voltage detector - Fazer 777

non-contact voltage detector - Fazer 777

H0314

Test pen for non-contact voltage detection with buzzer. It can detect AC current up to 500V and DC current up to 60V. 

This detector complies with IEC61010 standards: pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) and double insulation

Add to wish list
Spend 100€ to get a 3% discount for all your orders within the next 12 months and even higher discounts for higher spend. Click here to review loyalty program rules

Test pen for non-contact voltage detection with buzzer. It can detect AC current up to 500V and DC current up to 60V. 

This detector complies with IEC61010 standards: pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) and double insulation.

Features of the non-contact voltage detector - Fazer 777:

This voltage detector pencil is a device that should be included in the equipment of everyone who carries out even the simplest electrical work . Thanks to such a device, we can check if there is electricity on a given network element. The simplest and most common ones look like a flat screwdriver. But you can also find more advanced voltage testers for sale. An example of such an advanced tester is this FAZER 777 DETECTOR. It is intended for basic exercise. Testing of 220V / 380 electrical installation, car installations and other electrical installations.

Fazer 777 can also check correct operation of electrical devices. In electronics, Fazer 777 will allow us to check, among other things, whether the resistor, capacitor, diode and transistor are not damaged. The irreplaceable function of Fazer 777 is to detect voltage without touching the tested object. Fazer detects wires passing through walls to a depth of up to 10 cm. It will also detect "PHASE" where direct contact is impossible. Together with the Frazer 777, it is also very easy to detect wire breakage in insulation. The detection sensitivity setting on this probe allows it to detect voltage from a distance of 0.3 cm to 50 cm (depending on external conditions). The precise and refined design of the Fazer 777 processor system means very low power consumption, the average LR44 alkaline batteries will provide over 10,000 indications.

Specifications of the Non-Contact Voltage Detector - Fazer 777:

  • audible signalling device
  • detector switch
  • detection rate
  • CONT contact
  • optical indicator
  • battery cover
  • sensitivity regulator
  • VOLT contact
  • safety cover
  • measuring pin

Technical specifications:

  • Drive continuity test: ~ 1 MOhm.
  • AC phase/zero detection: 500 V.
  • DC voltage detection: 60 V max.
  • Wire detection: live (non-contact): 0,3 cm - 50 cm

Customers who bought this product also bought

Relay Module DC 12V 10A 1 Channel Low/High Trigger

Relay Module DC 12V 10A 1 Channel Low/High Trigger features:
- Channel: 1 (protected with Optocoupler)
- Supply voltage: 12V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- Trigger signal type jumper (low / high)
- LED indicator
- Dimensions: 30x 54mm
- Has a jumper that allows to choose type of trigger signal (low / high)

RL003

Price €2.29

Helping Magnifying Hand Tool

It is a very ideal tool when the third hand is required.
Helping Magnifying Hand Tool features:
- Magnifying glass diameter 60mm
- Weight: 0.5kg
- Dimensions: approx. 15 (26) x 17 x 7cm 

H0011

Price €7.95

XL6009 DC-DC Step-Up Booster Controller LM2577

- The XL6009 module has a superior performance than the LM2577 module
- The regulator-booster of High performance
Characteristic:
- Based on the XL6009E1 regulator
- Input voltage: 3V-32V,
- Output voltage: 5-35V (adjustable),
- Output current: 2A maximum 3A (heat sink is required)
- Conversion efficiency: up to 94%
- Rectifier: not synchronous rectification
- Short circuit protection: current limitation, since recovery
- Operating temperature: industrial grade (-40 ° C - 85 ° C)
- Load regulation: ± 0.5%
- Voltage regulation: ± 0.5%
- Size: 50 x 22 x 15 mm

A0005

Price €2.45

MT3608 2A DC Boost Step-Up Adjustable Power Module MicroUSB

MT3608 2A DC Boost Step-Up Adjustable Power Module MicroUSB features:
- Booster module
- The output voltage may be greater than the input voltage
- Use a multimeter to check the output voltage and adjust the potentiometer
- Input voltage: 2-24V
- Output voltage: 5-28V
- Current output: 2A - Operating temperature: -40ºC to + 85ºC
- Conversion efficiency: up to 93%
- Size: 17.5 x 30 mm

A0065

Price €1.69

Module TCRT5000 Infrared Sensor IR Tracker Line Obstacle

The optical module sensor (reflective) with comparator LM393, which detects obstacles with high precision.
The ideal obstacle detection detector for the installation of smart robots.
TCRT5000 - reflective optical sensor that has a compact construction where the light emitter and receiver are placed in the same direction to detect the presence of a object using infrared reflection on the object.
The working wavelength is 950nm.
The transmitter is infrared LED and the phototransistor receiver.
By using LM393 comparator the module has a binary output (D0) that is at level 1 (object is detected).
The sensor allows the detection of an object at a distance of up to 12 mm.

S0025

Price €1.85

TP4056 Lithium Battery Charger Module 5V Mini USB

TP4056 Lithium Battery Charger Module 5V mini USB features:
- Based on TP4056ES regulator
- Lipo mini USB Li-Ion charger
- Input Voltage: 4.5V - 5.5 VDC
- Full charge voltage: 4.2V +/- 1.5%
- Max Output Current: 1A
- Indicator LED: charging red, charging green
- Operating temperature: -10ºC to + 85ºC
- IN + and IN- connection for electronic circuits
- Battery protection against over-discharge voltage: 2.5V - Protection against over current battery: 3A
- Measurements: 25x19x5 mm
- Ideal for 18650 batteries

A0008

Price €0.99

Peltier Ceramic Cell TEC1 12706 12V 60W

Peltier Ceramic Cell TEC1 12706 12V 60W features:
- Max Power: 60w
- Voltage: 12v
- Max Voltage: 15,2v
- Max Current: 6A
- Temperature Variation: - Peltier effect cell model TEC1-12706, 12v, max 60w and 6A, with a temperature difference between their faces of up to 67ºC

M0055

Price €3.95
€7.89

6,52 tax excl.

Tax included
Out of stock
Do you want to receive an alert when product is back in stock?
 
We will send you an email once the product becomes available. Your email address will not be shared with anyone else.
Price €7.89

Order until 4pm we will send today
30 days return