Digital Car Multimeter LCD UNI-T UT107 Red

The digital clamp meters are designed according to EN61010-2010 CAT II 600V/CAT III 300V, with overload protection, high reliability, high safety and high accuracy. These meters can be used to measure high voltage frequency, AC/DC current, etc.

Modern digital multimeter with large LCD display that provides a better user experience. Voltage / current / resistance analysis,as well as diode, transistor and continuity tests.

This multimeter complies with IEC61010 standards: in pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) and double insulation.

The UT-07B-EU tester indicates the correct connection of L, N, PE cables in a socket. It also has a function to check the efficiency of residual current devices (RCD). The device is made of resistant plastic, which is very useful during installation work and ensures long-lasting correct operation. Attention! The RCD check is only possible if the phase is on the right-hand side.

FDY10-S is a new measuring device with integrated double function, detection and measurement.
During discharge, the LED shows the voltage, the current, the power in real time. After completing the battery discharge, it will display the results of the measurement, such as the download time.
The host and the heating elements are separated, high stability.
The measurement error is minimal and the most accurate results are due to the application of the measurement mode of the 4-wire system.
Availability to configure the automatic slide show function to verify visually and clearly the operating states and parameters, due to the display mode based on the combination of the LED indicator light.
Operation sound indication and alarm for the end of the discharge.

This connector is widely used in thermocouple and RTD circuits, giving a fast and good contact solution. It is designed with a good insulation, metal pins, its construction ensures a good contact.

Stabilized laboratory power supply with smoothly adjustable voltage in the range of 0 to 30 volts and current in the range of 0 to 5A. The power supply is fan cooled which allows the power supply to work in constant mode.

UT353 mini digital sound level meters can convert ambient sound into electric signals, process data and display results on LCD. They can constantly monitor ambient sound.

The main features are white backlight, clear LCD screen, adjustable sampling rate, fast/slow, 1/2 inch condenser microphone.

Light weight, ergonomic design, user-friendly interface.

With the logic signal state tester it is possible to detect 0, 1, high impedance states. The indication reading is displayed by means of LEDs. The supply voltage is 5-15V.

Modern digital multimeter with large LCD display that provides a better user experience. Voltage / current / resistance analysis, as well as diode, transistor and continuity tests.

This multimeter complies with IEC61010 standards: in pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) and double insulation.

Digital Multimeter M830BUZ Voltmeter features:
- Uni-T M830BUZ Digital LCD Multimeter AC DC Voltmeter Ammeter
- Maximum voltage between terminals and physical earth: 600V
- Power supply: 9V battery
- Protection: F 250mA / 250V
- Display: LCD, range up to 1999 update: 2-3 / s
- Method: double A / C slope
- Indication of exceeding the range: on the screen only by the number "1"
- Polarization of traffic for negative visualization "-"
- Operating temperature: 0 ° C ~ 40 ° C (32 ° F ~ 104 ° F)
- Storage temperature: -10 ° C ~ 50 ° C (10 ° F ~ 122 ° F)
- Flat battery signal: the screen shows "BAT"
- Dimensions: 125x70x25 mm.
- Weight: 170 g.
- Dedicated connections: CAT II 600 V