Hantek 365A - Virtual Multimeter for PC and iPad, Datalogger and Recorder

Modern compact digital multimeter with large LCD display that provides a better user experience.

This multimeter complies with IEC61010 standards: in pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) and double insulation.

This Hantek CC-65 clamp is a special accessory for oscilloscope by means of BNC connector, which allows to measure the parameters and current waveforms. Its current transducer linearly transforms AC or DC current into AC or DC current voltage. By connecting the current clamp to an oscilloscope, the waveform of the current signal can be observed.

This attenuator allows the oscilloscope to measure the fuel injector and primary ignition waveforms. Passive attenuator with a 20:1 attenuation Therefore, if a 20V signal is introduced, it will emit a 1V signal. Using this element, the oscilloscope can measure voltage higher than its range (*20V)

FDY10-S is a new measuring device with integrated double function, detection and measurement.
During discharge, the LED shows the voltage, the current, the power in real time. After completing the battery discharge, it will display the results of the measurement, such as the download time.
The host and the heating elements are separated, high stability.
The measurement error is minimal and the most accurate results are due to the application of the measurement mode of the 4-wire system.
Availability to configure the automatic slide show function to verify visually and clearly the operating states and parameters, due to the display mode based on the combination of the LED indicator light.
Operation sound indication and alarm for the end of the discharge.

The UT-07B-EU tester indicates the correct connection of L, N, PE cables in a socket. It also has a function to check the efficiency of residual current devices (RCD). The device is made of resistant plastic, which is very useful during installation work and ensures long-lasting correct operation. Attention! The RCD check is only possible if the phase is on the right-hand side.

Modern compact digital multimeter with large LCD display provides and enhanced user experience. Voltage / current / resistance / capacitance analysis as well as diode, transistor and continuity testing.

This multimeter complies with IEC61010 standards: in pollution degree 2, overvoltage category (CAT I 1000V, CAT II 600V) and double insulation.

The digital clamp meters are designed according to EN61010-2010 CAT II 600V/CAT III 300V, with overload protection, high reliability, high safety and high accuracy. These meters can be used to measure high voltage frequency, AC/DC current, etc.

The UNI-T UT300H temperature meter, which uses the latest technology, enables temperature measurements in the range of 32°C-42.9°C. The high accuracy of the device enables fast and accurate monitoring of body temperature as well as other environmental elements, e.g. objects, food, liquids, etc.

Super simple laser distance meter with a range of 20 metres and high accuracy.

Functions:

automatic switch-off

single measurement

laser pointer

Stabilized laboratory power supply with smoothly adjustable voltage in the range of 0 to 30 volts and current in the range of 0 to 5A. The power supply is fan cooled which allows the power supply to work in constant mode.