Magnifying LED Lamp Lens 5 Inch

2x Female 40-Pin Long Strip features:
- Pin spacing: 2.54mm
- Pin length: 10.5mm
- Insert position: vertical - Insertion: through
- Quantity: 2 units of female strips of 40 pins each

Ceramic Capacitor 1nF 50v 102 PCB PIC Arduino features:
-Type: Ceramic Y5P
-Tolerance: +/-10%
-Dimensions: diameter 6mm, pitch 5.08mm

SONOFF Basic R3 Intelligent Switch offers you perfect intelligence control solutions for your home or workplace. By using the wireless control of the free "eWeLink" application, it helps simplify your life so easily.

Blue 2 pole PCB mount screw terminal 5.08mm pitch Printed Circuit Board Terminal 2 poles 5.08mm pitch features:
Number of Contacts: 2
Pitch: 5.08mm
Number of Rows: 1
Mounting Type: PCB
Gender: Male
Allowable Section: 1.5mm2 (22- 14 AWG)
Termination method: screw
Type: screw terminal block
Nominal current: 16A
Nominal voltage: 250V
Color: blue
Material: Nylon 66
Depth: 10mm
Width: 7.5mm
Length: 10mm

A compact, low-power Bottom Effect System Transceiver.
Transceiver based on the SI4463 Silicon Labs chip.
Industry standard model.
In full power operating conditions, open the communication distance up to 2000 km.
Much more than the SI4432.
Si4463 is a high performance 433 MHz transceiver. and low current consumption of the EZRadioPRO series, which includes a complete transmitter and receiver.
Higher sensitivity -126dBm.
The maximum output power of + 20dBm, support (G) FSK, 4 (G) FSK, (G) MSK, OOK and ASK modulation.
The data rate in the range of 100bps ~ 1Mbps.
Operating voltage of 1.8V ~ 3.6V.
FCC approval / IC. 2km radius SI4463 433MHz RF Arduino Telemetry features:
- Supply voltage: 1.8 ~ 3.6VDC

LITHIUM POLYMER BATTERY Battery LIPO 2650mAh 3.7V features:
-Battery type-lithium polymer. - Type of battery terminals- 3 wires. -Voltage of the battery-3.7 V -Capacity of the battery- 2650 mAh. - Embedded PCM security chip (protection against overload, over discharge, short circuit). Dimensions: -Length / depth of the battery- 71 mm -Width / diameter of the battery- 95 mm It has three cables with a 3-pin connector with a separation of 2 mm. Cables: Red: positive. Black: negative. Yellow: thermistor output.

Male 40 Pin Header 1x40 features: Type: Male, Insertion position: Vertical, Separation between pins: 2.54mm

It has an ON / OFF switch that will cut off power when you don't need it.
USB to Micro USB On/Off Switch Arduino Charger Cable features:
- Black color
- Length: 150cm
- Maximum current 1A