Lead Screw with Trapezoidal Nut T8 50cm L8

Ideal for 1.75mm filament.
The tube is cut in lengths from 1m to 10m. PTFE Tubing ideal for feeding 1.75mm filament into an extruder or for use as a bowden tube.
Tubing cut to lengths of 1/2/3/4 / 5..10metres.

4x Nozzle Head 1.75mm 3D Printer MK8 Extruder Reprap features:
- MK8 Precision Nozzle: 0.2 / 0.3 / 0.4 / 0.5mm
- Material: Copper
- Size: 13mm x 6mm
- Suitable for Filament: 1.75mm
- Quantity: 4 units

RepRap Arduino Mega Pololu Shield (RAMPS) version 1.4 for 3D printer. RAMPS is a shield for the Arduino Mega - The outputs of the Arduino board are redirected to the motor drivers. To have the complete electronics for a 3D printer you need a RAMPS, an Arduino Mega and at least four stepper motor drivers

The module has two outputs: analog A0 and digital D0
Digital output D0 - signal 0 appears or 1 depending on the threshold setting
The threshold is set with the potentiometer
The sensor can be used for example:
Automatic watering for potted plants
With this module you will be able to measure the humidity of the soil, so that you will be able to control the humidity level of the soil of your plants
Characteristic:
Operation: 3.3V -5V
- Sensitivity adjustable by potentiometer
- Dual output mode: analog and digital
- Red LED - power indicator
- Green LED - indicator digital switching output
- PCB measurements: 3 x 1.5 cm
- Probe measurements: 6 x 3 cm

It has an automatic voltage regulator, which for practical purposes results in quieter operation and less vibrations.
Characteristic:
- Minimum operating voltage: 8 V
- Maximum operating voltage: 45 V
- Maximum current: ± 2.5 A (24V, adequately ventilated or refrigerated)
- Logic voltage: 3 V / 5.5V
- Microstep resolution: full, 1/2, 1/4, 1/8 , 1/16, 1/32
- Factory soldered temples
- 4-layer PCB, 2 oz. Copper for improved heat dissipation
- Short-circuit and overtemperature protection - Use potentiometer to adjust the current
- Measurements: 20x16x12 mm

Characteristic: - Supports up to 280ºC
- Electrical and antistatic insulation
- Resistant to acid and alkaline products
- Resistant to solvent
- Adhesive
- Length Approx: 33m
- Polyamide adhesive tape 10mm 
- Known as Kapton polyamide tape
- Product for welding works on those that need to protect some component from the heat

Servo Arm 25T Aluminium for Futaba MG996 MG995 Hitec JR features:
- 25T Servo Arm for Futaba, Tower Pro and High Power Servos
- Material: Aluminum
- Color: red
- Size: 35.5 x 15 x 6mm
- Weight: 4 grams
- M3 thread for joints of cars or helicopters.
- Hole distance 20 and 24 mm from the servo outlet.
- Quantity: 1 unit