Resettable fuse PTC 100mA 60V DC

Version compatible with Arduino Nano V3.0
It has an ATMega328P chip running at 16Mhz with bootloader loaded factory.
Characteristic:
- Microcontroller: ATmega328
- Operating Voltage (logic level): 5V
- Input Voltage (recommended): 7-12V
- Digital I / O Pins: 14 (6 PWM outputs)
- Analog Inputs: 8 (A0-A7)
- DC Current per I / O pin 40 mA
- Flash memory: 32 KB (2 KB used by the bootloader)
- SRAM: 2 KB
- EEPROM: 1 KB
- Frequency Clock: 16 MHz
- USB Communication - CH340
- Dimensions: 18 mm x 44 mm

The Carbon Monoxide sensor is a low-power digital gas sensor which has a CCS811 sensor and an 8-bit microcontroller, contains an analog-digital converter so that it can detect indoor air quality which can detect monoxide carbon (CO) and a wide range of volatile organic compounds (VOCs). It is a sensor designed to monitor air quality inside personal devices such as mobile devices and smart watches, with low power consumption that can be used with battery

Jack Stereo 3.5mm Female Connector Chassis 5P features:
- Type: Stereo
- Welding connections
- 3.5 mm connector for PCB mounting

NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance.   Thermistor NTC 100.0K 5% MF52A epoxy resin coating resistor features:

Size: 3mm
Rated resistance: R25 = 100.0k
B value 25/85 = 3950°K
Rated power: ‰¤ 50mW
Tolerance:± 5%
Operating temperature: from -40°C to +125°C  Tinned steel wire 25mm

This switch can be used for development projects and for the industry. All metal parts are not oxidized, the insulation material is of high quality.
Its pins protected by an anti oxidant makes welding much easier. Switch On/On 6-pin 6A SPDT features:
- Type: Latch SPDT
- Material: Plastic, metal
- Maximum operating current and voltage: 3A / 250V, 6A / 125V
- Number of pins: 6
- Pin size: 4.5x2 mm
- Type of current: AC
- Pins to be welded
- Switch action: 2 positions On/On
- Size: 13.2x12.7x33.3mm

WROOM-32 DEVKIT V1 is an ESP32 processor development board with WiFi and Bluetooth (BLE). It is much faster than the ESP8266 processor (NodeMCU and similar), and very easy to use, with 2x15 pins.

2 Cables for 1M Multimeter Meter features:
- Voltage 1000V, 10A CAT III
- Total length 110cm
- Red and black colors

Buzzer alarm to convert electrical to acoustic signals in robotics devices and Arduino projects.
Buzzer 5V Active Buzzer 4 to 7V DC features:

- Input voltage: 4V to 7V
- Diameter: 12mm
- Height: 9.5mm
- Spacing Pins: 7.6mm
- Maximum Current: