Flat Cable 1m AWG28 1.27 Gray 10 Pins

Ideal for your electronic projects, Arduino, but can also be used with other microcontrollers.

For connecting Arduino modules or boards.
Ideal for your electronic projects, arduino, but can also be used with other microcontrollers. 2x Cable Female - Female 4 Pins 4 Colors features:
- No soldering required
- Circuits can be easily modified or revised
- Quantity: 2 cables of 4 pins, female - female connector
- Colors: red, black, blue, green
- Pin pitch: 2.54mm
- Cable lengths: 70cm For one rapid construction of a prototype of an electronic circuit.

Limit Switch with Wheel - 5A 250 Vac - 1 switched - Arduino features:
-Micro KW12-3 on / off switch
-Max Current: 5A -AC voltage: 125-250V
-Operating temperature: -40 to 70 degrees C
-Quantity: 2 units

LED 5mm RGB 4 Pins cathode commun with clear water lens.

WIFI transceiver based on the ESP8266 controller.
It has a microcontroller and 2 GPIO pins to be able to operate autonomously without the need for an external microcontroller. Characteristic: - Voltage of power: 3.3V
- Supported protocols: 802.11 b / g / n
- Network support: 2.4 GHz
- Band: 2400 (MHz)
- Wi-Fi Direct (P2p), Soft Access Point
- Integrated TCP / IP stack
- PLL, regulators and integrated power management units
- Output power: 0.15 (W); + 19.5dBm in 802.11b mode
- Consumption in low power mode:

Characteristic: - Cable 13cm long
- Measurements 49x 52x 13mm
- Battery length max 44mm
- Compatible batteries (LR03, 24A, R03, RX03, MN2400, AM4, UM4)

Characteristic:
-Metric thread M3
-Male-Female separator 25mm
-Quantity: 5 units

It allows controlling many different types of engines: - Up to 4 bidirectional current motors
- Up to 2 stepper motors (unipolar or bipolar) In addition it is provided with two connectors for servos.                   L293D Motor Drive Shield Expansion Board features:
- Minimum operating voltage: 4.5 V
- Maximum operating voltage: 36 V
- Maximum current: ± 1.2 A (650mA)
- Logic voltage: 5V
- Controller L293D
- Measures: 70x55x20 mm L293D controller consists of 4 H bridges with 650 mA current with thermal protection.
Pull-down resistors keep the motors off during startup.