ABS 20x Colors Filament 1.75mm 5m

It allows controlling up to 2 direct current motors or a bipolar stepper motor. It also allows to control a unipolar stepper motor configured as bipolar.
Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32.
L298N Motor Drive Controller Board Module Dual H Bridge DC features:
- Minimum operating voltage: 5 V
- Maximum operating voltage: 35 V
- Maximum current: ± 2 A
- Logic voltage: 5V
- PWM signal inputs for speed control
- Outputs: for 2 DC motors or for a bipolar stepper motor
- Measures: 43x43x24 mm
Helpful Links:
Operation of the robot by Infrared / Operation of the robot by Bluetooth / Automatic operation with detection of obstacles

Crocodile Clip 30A 2x75mm Black + Red features:
- Length: 75mm
- Handle length: 38mm
- Isolated
- Quantity: 2 units

Connectors 10x BLS05 Female/Female 5 Pins RoHS Single Row features:
- Step between pins: 2.54 mm
- Manufacturer: Maritex
- Number of connections: 5 in a single row
- Type: female / female
- RoHS standard

The 2.5mm female jack connector is a connector to provide power to computers, LED TVs, routers, etc ...
This 2.5mm female jack connector adapter soldered on a PCB board, is ideal for use in our projects.
It has connection points where we can easily solder some pins to connect it directly to a breadboard, or solder a cable over those same connection points.
Adapter 2.5mm female power jack with PCB features:
- Connector type: 2.5mm female jack ,
- Color: black,
- Nominal voltage: 12v DC,
- Maximum current: 0.5A DC,
- Insulation resistance: ‰ ¥ 100MΩ,
- Operating temperature: -25ºC to + 85ºC,
- Number of output pins: 3
- Pitch between output pins: 2.54mm.

3A DC Converter 1,25-32V Adjustable LM2596 Step Down Module features:

- Based on the LM2596S-ADJ regulator
- Rectification: Asynchronous
- Output Voltage: 1.25v - 32v DC (adjustable)
- Voltage of Input: 3.2v - 35v DC
- Max Output Current: 3A (with heat sink)
- Ripple at output voltage: 30mV
- Frequency: 150KHz
- Max Conversion Efficiency: 92%
- Load Regulation: ± 0.5%
- Voltage Regulation: ± 2.5%
- Operating Temperature: -40ºC to + 85ºC
- Measurements 43x 21x 14 mm

Jack connectors 2.1mm inside and 5.5mm outside to power devices such as LED strips, CCTV (Cameras), Arduino. Female DC Power Connector Jack 2.1x5.5mm features:
- Ideal for connecting without welding
- It has two screws in the tip for positive and negative cable screwdriver

Screw Shield V1- Arduino ScrewShield UNO y MEGA features:
Screw Shield V1 allows: - Being punctured directly to an Arduino Uno, Mega, Leonardo plate
- Facilitate the connection of different modules, such as sensors, relays, servos, buttons, potentiometers and more.

40x Cables Female-Male 20cm features:
-Length: 20cm
-Quantity: 40 cables
-Connectors have male and female header contacts at either end
-Compatible with female connectors 2,54mm
-High quality and good working conditions
-Easy to install and use