15x Electrolytic Capacitor 10uF 25V 105ºC PIC for Arduino

Characteristic: - Diameter: 35mm
- Frequency: 2.3 kHz
- Impedance (resonance): 300 Ohm
- Capacity (at 1kHz): 25,000 pF
- Dimensions: 35x0.50mm

TP4056 Module Lithium Battery Charger with Protection features:
- TP4056 Li-Ion Micro USB Charger
- Upgraded version of previous TP4056
- Micro USB connection to charge directly from the PC
- Ideal for 18650 batteries
- Based on the TC4056A regulator
- Input Voltage: 4.5V - 5.5V DC
- Full charge voltage: 4.2V +/- 1.5%
- Max Output Current: 1A
- Overvoltage protection 4.2V
- Over discharge protection 2.4V
- LED indicator: charging blue, charging red
- Operating temperature: -10ºC to + 85ºC
- IN + and IN- connection for electronic circuits
- Overcurrent protection: 3A
- Measurements 26 x 19 x 5 mm
- Possibility of current change through Rprog

Characteristic:
- Tolerance: +/- 20%
- Power: 0.125W

WROOM-32 DEVKIT V1 is an ESP32 processor development board with WiFi and Bluetooth (BLE). It is much faster than the ESP8266 processor (NodeMCU and similar), and very easy to use, with 2x15 pins.

This module includes the BMP280 component that converts atmospheric pressure, temperature and humidity with high precision into a digital signal.
The equipment uses the two I2C and SPI interfaces. The very good measurements made by the BMP280 allows the module to be used as an altimeter.
Its 5-pin straight connector allows easy connection to other electronic boards. BMP280 Temperature Barometric Pressure Sensor Module/SPI features:
- Interfaces:
       -I2C (up to 3.4 MHz)
       -SPI (up to 10 MHz)
- Supply voltage: 1.8-5VDC
- Module operating range:
       - Temperature: -40ºC to + 85ºC
0-100%
       - Pressure: 300-1100 hPa
- Resolution of the measures:
       - Temperature: 0.01ºC

The perfect Arduino sensor kit to start learning about the world of electronics with Arduino. It comes with our step-by-step guide to each sensor, as well as its libraries. 

RTC DS3231 clock module with EEPROM 32k.
High precision RTC module.
Can be used in projects of Arduino, PIC, AVR, STM32 and other.
DSC321 AT24C32 with Real Time Clock RTC Battery features:
- Based on DS3231
- EEPROM AT24C32 (32K)
- I2C interface
- LED work indicator
- Includes CR2032 3V battery

2x Bridge Rectifier GBU10M - 10A/1000V features:
- Maximum reverse voltage: 1000 V
- Vf - Front tension: 1.0 V
- Current If (av) - 10A (with heat sink)
- Max. Overvoltage current: 250 A
- Minimum operating temperature: - 50 C
- Maximum operating temperature: + 150 C
- Go - Reverse current: 5 uA
- Quantity: 2 units