Pipeline Valve controller 1/2″ inch ZigBee 3.0 TUYA

Water/gas ball valve controller Zigbee 3.0 for water/gas leak detectors. Wireless remote control, timer function, iOS/Android compatible.

Main Benefits :

Remote control from anywhere in the world with the TUYA/SMART LIFE app, full app support.
Compatible with all TUYA/SMART LIFE devices.
Allows the creation of schedules and can be linked with other devices for complex scenarios.
Easy to install. No need to interfere with existing infrastructure. The controller is placed on standard lever ball valves.
Secure 12V power supply.
The controller has a clutch pin that allows the lever to be manually repositioned.
Simple Wifi pairing like all other TUYA devices, press and hold the power button for about 7 seconds to activate Wifi pairing mode.
Allows you to adjust, from the app, the water flow manually.
The controller is waterproof.

Note:

The controller can only be used on 1/2 inch pipe valves.
The controller attaches to the ball valve from above. The ball valve lever is inserted between the valve mounting bolts.
After actuation, the controller moves the arm, moving the lever to the off or on position.
Make sure you have enough space above the valve to fit the controller.
For remote use requires the application: "Smart Life" or "TuyaSmart".
You can control it manually thanks to the buttons on the housing

Attention! For this device, you need the TUYA ZigBee 3.0 gateway available in our offer:

The Zigbee protocol operates on the 2.4 GHz frequency which propagates well in the building.
Zigbee connectivity is MESH connectivity, which means that each Zigbee device acts as a relay for all other devices. If the remote sensor does not communicate with the Zigbee Gateway, it is sufficient that it has radio communication with another sensor that communicates with the gateway. The devices operate in a chain of mesh connections, ensuring a reliable and secure connection.
Zigbee devices and sensors consume very little power, resulting in a long battery life.
Devices using the Zigbee protocol connect to the control panel in case of a status change within 0.2 seconds. Wifi devices take about 5 seconds to connect to the Wifi network after a status change. ZigBee devices have a great advantage in smart rule automation.
Most of the configured automation of ZigBee devices is done at the local gateway. Not in the cloud. A typical rule> If motion is detected (PIR detector), turn on the light, the execution time is about 0.5 seconds.
The execution time of the same rule on WiFi devices is approximately 3-7 seconds.
The Zigbee gateway and Zigbee devices allow for much larger and longer storage of parameter data and device history. Door opening history, temperature history, motion detection history recorded months back.