10x Zener Diode BZX85C3V6 3.6V 1.3W DO-41

Through-hole LED for 12V DC with black and red 20cm cable.

• Diode type: with cable
• LED lens type: Clear
• Direct diode voltage: 12V
• LED colour: light yellow 
• The distinguishing feature: 12 V LED with 20 cm RoHS cable
• LED size: 3 mm

Strip of 300 warm white coloured LED lights, 5 metres long.

LED Diode Assortment Kit 30 pcs 5mm red, green, yellow features:
- Lens color: red, green, yellow - diffuse
- Size: 5mm
- Operating current: 20mA
- Voltage (red) 1,8V-2,3V
- Voltage (green) 3,2V-3,4V
- Voltage (yellow) 1,8V-2,3V
- Anode (A): Positive (long leg): 28mm
- Catode (K): Negative (short leg): 25mm
- Operating temperature: -25ºC/80ºC
- Welding temperature: +260ºC
- Quantity: 30 units
*10x red
*10x green
*10x yellow

Mount LED Diode on a good heatsink, a metal plate, add a fan, this is necessary because you have to "remove" the heat from the surface of the board so that the LEDs last longer to place a little bit of thermal silicone in each of the diode's placement centers.
The thermal paste increases the thermal transfer between the diode and the metal plate used as a circuit.
Important to keep in mind the diodes generate a lot of light intensity and very concentrated.
Avoid looking directly at them once they are turned on and wear protective glasses when working with them. Characteristic: - Chip 28x47mil
- Voltage: 3.1-4.1V
- Current: 700mA
- Luminous flux: 39-55LM
- Ã beam angle: 120 degrees
- Color emission: blue

WS2812B are LEDs that have built-in logic, making it possible to vary the color of each LED individually.
WS2812B includes a integrated inside each LED, which allows each pixel to be accessed individually.
For this reason, these types of LEDs are called individually indexable.
They are based on the 5050 LED. 

Mount LED Diode on a good heatsink, a metal plate, add a fan, this is necessary because you have to "remove" the heat from the surface of the board so that the LEDs last longer to place a little bit of thermal silicone in each of the diode's placement centers.
The thermal paste increases the thermal transfer between the diode and the metal plate used as a circuit.
Important to keep in mind the diodes generate a lot of light intensity and very concentrated.
Avoid looking directly at them once they are turned on and wear protective glasses when working with them. Characteristic: - 32mil Chip
- Voltage: 2.2-2.4V
- Current: 300mA
- Luminous flux: 40-50LM
- Ã beam angle: 120 degrees
- Color emission: red

Addressable 5050 RGB LED bar (5mm x 5mm) with low current draw. LEDs can be joined by connecting the output of one module to the input of another.
Data line with a very specific protocol, requires a real-time microcontroller AVR, Arduino, PIC, mbed, etc. A minimum 8 MHz processor is required.

Red LED indicator light for machinery lights