LED 5mm RGB Cathode Commun

10x Tactile Tact Push Button Switch 6x6x8mm features:

- Tactile Push Tact Switch mini electronic Arduino pushbutton
- Measures: 6x6x8mm
- Quantity: 10 units

Resistor 10K Ohm 5% 0,25W 1/4W features:
-1 unit - 10K Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Led module infrared sensor for Arduino
Detector of the source of fire or flame, can detect a flame or wavelength 760 nm-1100 nm
Particularly sensitive to the flame spectrum.
This optical flame sensor is a device that detects the existence of combustion by the light emitted by it.
Infrared LED Flame Sensor 5mm module features:
- 4 Pins Output:
    - A0: analog output
    - D0: digital output
    - GND: ground connection
    - VCC: 5V module power
- Range of light, Distance of 80 cm.
- Angle detection of about 60 degrees,
- This light can be detected by an optical sensor,
- Can be captured by digital inputs and analog inputs of Arduino.

Blue 2 pole PCB mount screw terminal 5.08mm pitch Printed Circuit Board Terminal 3 poles 5.08mm pitch features:
Number of Contacts: 3
Pitch: 5.08mm
Number of Rows: 1
Mounting Type: PCB
Gender: Male
Allowable Section: 1.5mm2 (22- 14 AWG)
Termination method: screw
Type: screw terminal block
Nominal current: 16A
Nominal voltage: 250V
Color: blue
Material: Nylon 66
Depth: 10mm
Width: 7.5mm
Length: 10mm

Descent module.
Use a multimeter to check the output voltage and adjust the potentiometer.
Control of tension.
LM2596 DC Voltmeter Converter 3A Step Down Adjustable Power features:
- Input voltage: 4.5-38V
- Output voltage: 1.25-36.5V
- Current output: 2A (max 3A with heat sink)
- Operating temperature: -40 to + 85 ºC
- Operating frequency: 150KHz
- Efficiency conversion: up to 92%
- Load Regulation: +/- 0.5%
- Voltage Regulation: +/- 2.5%
- Protection over temperature: the output switches off automatically
- Size: 62mm x 38mm x 15mm
Principal functions:
- Step-down converter with overcurrent protection
- Voltmeter up to 40V, remember to set the input voltage to 4.5V

Photoresistance is a resistor whose resistance decreases as the intensity of the light that falls on it increases. 10x Photoresistor GL5539 LDR 50k - 100k features:
- Model: GL5539
- Spectral peak: 540nm
- Maximum DC voltage: 150V
- Maximum power: 100mW
- Resistance with light (10lux): 50-100KΩ
- Resistance with darkness (0lux): 5MΩ
- Response time: 20ms
- Operating temperature: -30ºC - 70ºC