LED Diode Assortment Kit 40x Red Green Yellow Blue

The perfect Arduino sensor kit to start learning about the world of electronics with Arduino. It comes with our step-by-step guide to each sensor, as well as its libraries. 

TB6612FNG controller, double H-bridge controller driver.
Allows to control up to 2 current motors continuous or bipolar stepper motor. It also allows to control a unipolar stepper motor configured as bipolar.
Ideal for projects with ARDUINO. You can use it with PIC, AVR, STM32.
An improved version of the L298N.
H-bridges are made up of MOSFET transistors, rather than BJT transistors as in the L298N.
The TB6612FNG has better efficiency and smaller dimensions than the L298N.
Controller TB6612FNG DC PAP motor features:

- Minimum operating voltage: 4.5 V
- Maximum operating voltage: 13.5 V (15V max)
- Maximum current: ± 3A per channel (1.2 A direct current per channel)
- Logic voltage: 5V

50cm HDMI V1.3 Male to Raspberry PI 1080P Gold Silver features:
- For Raspberry Pi 2 and Pi 3, B and B +
- HDMI V1.3b cable and full 1080P (category 2) resolution
- Type A male at both ends
- High quality gold shielded connectors
- Manufactured with high quality copper conductors (OFC-Oxygen Free Copper- 99.99%) that guarantees the highest transmission quality
- Refresh rates up to 120Hz
- Length: 50cm
- Quantity: 1 unit

Push button 6x6x4mm features:
-Touch Push Tact Switch mini electronic Arduino push button
-Measures: 6x6x45mm
-Quantity: 1 unit

Easily convert water level to analog signal
The analog output signal can be read directly on the Arduino board
Characteristic:
- Operating voltage: 3.3V -5 V
- Consumption: less than 20 mA - Sensor type: Analog
- Operating temperature: 10º C -30º C
- Detection area: 40 mm x 16 mm
- Dimensions: 60 mm x 20 mm

NTC thermistor - with a negative temperature coefficient, i.e. an increase in temperature causes a decrease in resistance.   Thermistor NTC 10.0K 5% MF52A epoxy resin coating resistor features:

Size: 3mm
Rated resistance: R25 = 10.0k
B value 25/85 = 3950°K
Rated power: ‰¤ 50mW
Tolerance:± 5%
Operating temperature: from -40°C to +125°C  Tinned steel wire 25mm

It can be used to work with AVR, ARM, PIC microcontrollers, Arduino modules and to work with self-designed prototypes. Arduino Protoboard Breadboard 400 points features:
-400 Connections
-Linkable with other Plates
-Base with adhesive to attach it to the work surface
-Measures 82x55x8 mm