Set of flat transmission belts - width 4.0mm

Embellisher features:
- Color black and red, white, yellow, orange
- Upper diameter: 0.9 cm
- Lower diameter: 1.5 cm
- Height: 1.6 cm
- Inside hole diameter: 0.6 cm

This module can be directly controlled by the microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, from the TTL 8 Channel High Trip 5V 10A Relay Module features:
- Channels: 8 (independent protected with Optocouplers)
- Supply Voltage Vcc: 5Vdc
- Output Current: 10A
- High trip min 3.3V input IN1. ..IN8
- Relay activation current: 5 ~ 10mA
- Isolation: Yes
- Indicator LED: For each channel
- Dimensions: 55x 139mm
- Weight: 120g
COM GND jumper input: connects GND optocouplers and GND of the circuit

It has an automatic voltage regulator, which for practical purposes results in quieter operation and less vibrations.
Characteristic:
- Minimum operating voltage: 8 V
- Maximum operating voltage: 45 V
- Maximum current: ± 2.5 A (24V, adequately ventilated or refrigerated)
- Logic voltage: 3 V / 5.5V
- Microstep resolution: full, 1/2, 1/4, 1/8 , 1/16, 1/32
- Factory soldered temples
- 4-layer PCB, 2 oz. Copper for improved heat dissipation
- Short-circuit and overtemperature protection - Use potentiometer to adjust the current
- Measurements: 20x16x12 mm

Soldering Gun with Dual Color 30W/70W features:
- Power: 30W, maximum 70W
- Power: 230V
- Equipped with tip B1
- Long length tip: 1mm
- Anti-thermal handle
- CE, RoHS and TÃœV certifications Instructions: When connected, the initial power runs at 30W.
When you press the button, the energy runs around 70W.
When you release the button, the power will slowly descend to 30W again.

5x Pushbutton B3F Green Key Omron Electronica Arduino Prototype Switch 12 features:
- 5x Pushbuttons B3F Omron
- 5x Keys
- Maximum current: 50mA
- Tension DC: 24V
- Operating force: 1.27N
- Switch terminals - Weldable
- Contact: SPST-NO
- Contact resistance: 100M Ohm
- Type of action: Superficial
- Measures: 12x12x7.3mm

IIC/I2C adapter PCF8574 LCD 1602 1604 2004 Interface features:
- Based on the PCF8574A chip
- Power: 5V
- Supports I2C Protocol
- A potentiometer for regulate contrast
- Dimensions: 19x42mm PCF8574 - & gt; the default address 0x20
PCF8574A - & gt; the default address 0x3F - You can change anyone between 0x20 and 0x27 depending on whether or not you have soldered pins A0 A1 A2 - With this module the communication between the Arduino and the LCD It is only made through two outputs, SDA and SCL
- Up to 8 LCD screens can be connected to the same I2C bus choosing a different address - Ideal for projects with ARDUINO and Raspberry Pi platforms - You can use it with PIC, AVR, STM32

Characteristic:
-Metric thread M3
-Male-Female separator 25mm
-Quantity: 5 units