Connectors 10x BLS05 Female/Female 5 Pins RoHS Single Row

Characteristic:
-Metric thread M3
-Male-Female separator 25mm
-Quantity: 5 units

Push button 6x6x4mm features:
-Touch Push Tact Switch mini electronic Arduino push button
-Measures: 6x6x4.3mm

Protoboard Breadboard Arduino 2900 points features:
-2900 connections
-Measurements: 20x24x2cm

Micro Servo Compatible with MG90S features:
- Operating voltage: 4.8Vdc (5V) or 6Vdc
- Torque: 1.80 kg / cm at 4.8V and 2.20kg / cm at 6V
- Speed: 0.1seconds / 60º at 4.8V and 0.8 seconds / 60º at 6V
- Gear type: metallic
- Turning width: 180º
- Temperature working: from -30 to 60 ºC
- 3 plastic propellers / arms
- Fixing screws
- Size: 22.6 x 11.8 x 31 mm
- Weight: 13.4 gr

Holder for ultrasonic, distance meter HC-SR04. Ideal for installing the sensor on mobile platforms such as robots, vehicles, etc.

Arduino compatible IR motion detector with a detection range of 7 meters and an operating angle of 120º.
An electric pyro sensor , which can detect infrared radiation levels - detect a change in the average IR levels of your detection zone.
Ideal for projects with ARDUINO, PIC, AVR, STM32. HC-SR501 Motion Detector Module Passive Infrared PIR Sensor features:
- Infrared sensor with control circuit
- Adjustable sensitivity and time
- Operating voltage: 4.5V- 20V
- Consumption in Idle state:

Momentary Switch Push Button Black N/O 7mm features:
- Momentary pushbutton N/O (normally open)
- Black button
- Dimensions approx. 7 mm x 27 mm
- Recessed with nut and washer
- Load current (supported): 1A to 230V / 2A to 125V
- Drill to embed: 7 mm +/- 0.2
- Operating temperature: -55ºC to + 85ºC

This module, which uses the exclusive L298P chip for driving high-power motors, can directly control two DC motors, with a drive current up to 2A. The motor output uses eight-speed Schottky diodes as protection.
The design of the letter allows you to connect directly to the Arduino UNO R3 for easier use. Module L298P DC 2A Motor Management Shield Bluetooth Interface PWM features:
- 1 logical step of the input voltage VD: 5 VDC
- Control of the input voltage VS and control by pulse width modulation:
      - VIN input: 6 - 12 VDC
      - PWRIN input: 4.8 - 35 VDC
- Logic current flow: Iss <36m A
- Operation current management: Io <2 A
- Maximum power dissipation 25W (T = 75 ° C)
- Input of the control signal: