Battery charger for 12V 1.5A gel batteries

Compact and fast processor charger Xtar SC2 for rechargeable Li-ion batteries of size 18650 and other sizes.

TP4056 Lithium Battery Charger Module 5V mini USB features:
- Based on TP4056ES regulator
- Lipo mini USB Li-Ion charger
- Input Voltage: 4.5V - 5.5 VDC
- Full charge voltage: 4.2V +/- 1.5%
- Max Output Current: 1A
- Indicator LED: charging red, charging green
- Operating temperature: -10ºC to + 85ºC
- IN + and IN- connection for electronic circuits
- Battery protection against over-discharge voltage: 2.5V - Protection against over current battery: 3A
- Measurements: 25x19x5 mm
- Ideal for 18650 batteries

Battery charger for 12V gel batteries with battery state of charge monitoring. Alligator clip connectors.

The Konnwei KW510 is an advanced multi-function device that uses state-of-the-art technology to allow you to easily, quickly and accurately measure the actual cold start capability, battery condition and common faults in the vehicle's starting and charging systems. The KW510 is particularly useful for workshops as it can accurately detect the problem, allowing the vehicle to be repaired quickly.

Charger for 1-cell lithium-polymer batteries with a nominal voltage of 3.7 V and lithium-ion batteries. The chip is powered via a USB plug, which can be connected directly to a computer socket or a power supply.

Konnwei's KW870 car battery tester is capable of effectively analysing and reading important car data such as voltage, internal resistance, cold start current and AH capacity. In addition, the device calculates cold-start capacity and the degree of ageing, allowing for faster and more accurate repairs. Whether you're a beginner or an expert, this car battery diagnostic device can be used with a wide range of 6-18 V batteries with a capacity of 100-2000 CCA, including traditional, flat AGM, spiral AGM and gel batteries.

The European plug-in charger for charging 4 rechargeable batteries at the same time, each charge is individually displayed. Advanced processor controls the charging process with "delta V" function.

Wireless charging and powering of small electronic products. It is designed for small size, ease of use, high performance and low price. Type-C High Power Fast Charging Module DC 5V 9V 12V 20W Wireless Charger Transmitter Circuit Coil Charger Board 0-8mm max 10mm

Wireless charging and powering of small electronic products. It is designed for small size, ease of use, high performance and low price. The main purpose of the module is to be used in the initial phase of projects such as mobile electronic products.

In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge.