PCB Round Heated Bed 200mm MK2Y 3D Reprap Printer

LCD 2004 Intelligent Reprap Controller 3D Printer can be connected directly to your RAMPS 1.4. All new operations, such as calibration, axis movement can be done only with the smart rotary encoder. You don't need to use your PC. Just use the G-Code layout stored on the SD card.

Extruder Kit MK8 Aluminium 1.75mm Strand 3D Printer Reprap Prusa features:
- MK8 1.75mm filament extruder kit
- Includes:
* MK8 extruder complete push system
* Square part dimensions: 40x40mm
* Part dimensions - handle L: 44x28mm

A4988 + RepRap Radiator features:
- Minimum operating voltage: 8 V
- Maximum operating voltage: 35 V
- Maximum current: ± 2 A (adequately ventilated or refrigerated)
- Logic voltage: 3 V / 5.5V
- Microstep resolution: full, 1/2, 1/4, 1/8, and 1/16
- Factory soldered temples
- Use potentiometer to adjust current
- Measurements: 20x16x12 mm

Sensor used to measure the temperature of the hotend or hot bed of your 3D printer
Characteristic:
- NTC Thermistor 100 K 3950
- Impedance: 100 K (25º of Temperature)
- Accuracy: 1%
- Sensor Diameter: 1.8 mm
- Cable Length: 1 m
- Cable: AWM UL 3398 150 ° C 300V
- Ready to be installed and used. Fully insulated
- Designed to withstand the high temperatures of extrusion of plastics such as PLA and ABS

Version compatible with Arduino Nano V3.0
It has an ATMega328P chip running at 16Mhz with bootloader loaded factory.
Characteristic:
- Microcontroller: ATmega328
- Operating Voltage (logic level): 5V
- Input Voltage (recommended): 7-12V
- Digital I / O Pins: 14 (6 PWM outputs)
- Analog Inputs: 8 (A0-A7)
- DC Current per I / O pin 40 mA
- Flash memory: 32 KB (2 KB used by the bootloader)
- SRAM: 2 KB
- EEPROM: 1 KB
- Frequency Clock: 16 MHz
- USB Communication - CH340
- Dimensions: 18 mm x 44 mm

Ideal for connecting RS485 devices to your PC through the USB port. USB to RS485 USB to 485 Max485 Converter features:
- CH340 controller
- Supported OS: Win XP, Vista, Win 7.8, OS, Linux
- Work with Modbus, Profibus
- USB 2.0 specification with 6Mbps of maximum speed
- Measures: 60x 18x 14 mm

In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge.

It allows removing the solder residues from the tips.
It cleans better and does not cause temperature drops like with sponges.
You do not need extra water to clean the tip.
Easy and effective cleaning at the tip.
Soldering Tip Cleaning Ball features:
- Dimensions: diameter 50mm