Plastic Box

- 4 RGB LED panel with digital control to be connected in cascade to complete the reception and decoding of the data
- The light emitted is very powerful and can generate millions of colors thanks to the RGB device Panel Boards with 4-bit Precise Control 4 RGB LED 5050 CJMCU-2812-4 5V features:
- Operating voltage: 5 V
- LED color: RGB
- Number of LEDs: 4 (2 rows and 2 columns)
- Intelligent reverse polarity protection, the reverse polarity of power supply will not damage the IC
- IC control circuit
- Very powerful LED light
- 4 polarities:
      - VCC: positive power voltage
      - GND: ground connection
      - IN: input signal for cascade connection
      - OUT: output signal for cascade connection

Blue sponge to clean the tip of your soldering iron to the tin.
Blue cleaning sponge for soldering iron tip features:
- Size: 50x35mm,
- Material: sponge,
- Color: blue,
- Quantity: 1.

Includes a switch to output the voltage built into the case itself.
It has a cover for protect the batteries.
The cover has perforation in case you want to secure it with a screw (not included).
Characteristic:
- Cable 12cm long
- Measures 70x 65x 18mm
- Battery length max 50mm
- Compatible batteries (LR06, R06, MN1500, AM3, UM3, HP7)

It has an ATMega32U4 chip running at 16Mhz with a factory-loaded bootloader. It does not include pins so we can solder only the pins we need. Characteristic: - Microcontroller: ATmega32U4
- Operation: 5V
- Power (max): 5-12V
- Total I / O pins: 20
- PWM pins: 5
- Analog pins: 12
- Maximum current of I / O pins: 40 mA
- Maximum current of pin 3.3V: 50 mA
- Flash memory: 32 KB (4 KB used by the bootloader)
- SRAM: 2.5 KB
- EEPROM: 1 KB
- Speed: 16 MHz
- external interrupt
- TWI / I2C, UART, SPI interfaces
- Dimensions: 18x33mm
- Weight: 30 grams

USB Cable A to Micro USB B 100cm for Arduino Leonardo, Due.

It has an ON / OFF switch that will cut off power when you don't need it.
USB to Micro USB On/Off Switch Arduino Charger Cable features:
- Black color
- Length: 150cm
- Maximum current 1A

Level sensor for liquids with float.
The liquid level sensor acts as a switch. The state is changed by means of a magnet located on the float. It can be used to detect liquid levels that are too high or too low.
Ideal for all those applications where it is necessary to control the level of non-corrosive liquids such as water tanks, aquariums.
Characteristic:
- Maximum Load: 50W
- Maximum Switching Voltage: 250V
- Maximum Switching Current: 0.5A
- Maximum charging current: 1A
- Operating temperature: -10ºC to + 60ºC
- Size: 58mm x 18mm

Arduino compatible IR motion detector with a detection range of 3 meters.
One sensor electric pyro, which can detect infrared radiation levels - detect a change in the average IR levels of your detection zone.
Ideal for projects with ARDUINO, PIC, AVR, STM32.
Characteristic:
- Operating voltage: 4.5V- 20V
- Consumption in idle state: