10x Male-Male Cables 20cm Jumpers Dupont 2,54

Micro Servo Compatible with MG90S features:
- Operating voltage: 4.8Vdc (5V) or 6Vdc
- Torque: 1.80 kg / cm at 4.8V and 2.20kg / cm at 6V
- Speed: 0.1seconds / 60º at 4.8V and 0.8 seconds / 60º at 6V
- Gear type: metallic
- Turning width: 180º
- Temperature working: from -30 to 60 ºC
- 3 plastic propellers / arms
- Fixing screws
- Size: 22.6 x 11.8 x 31 mm
- Weight: 13.4 gr

The first Raspberry microcontroller with the proprietary RP2040 chip and a dual-core Arm Cortex-M0+, the Foundation's cost-effective yet highly flexible solution. Designed for high performance and with a high degree of digital interfaces. Programming in C/ C++ and MicroPython.

Resistor 4.7R Ohm 5% 0,125W 1/8W features:
-4.7R Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.125W
-Dimensions: 1.85x3.5mm

Stepstick A4988 controller
Driver for stepper motors
Used with Ramps 1.4 - RepRapArduino Mega Pololu Shield
A4988 + Stepstick Radiator Stepper Motor Reprap features:

- Minimum operating voltage: 8 V
- Operating voltage maximum: 35 V
- Maximum current: ± 2 A (adequately ventilated or refrigerated)
- Logic voltage: 3 V / 5.5V
- Microstep resolution: full, 1/2, 1/4, 1/8, and 1/16
- Factory soldered temples
- Use potentiometer to adjust current
- Measurements: 20x16x12 mm

Linear Bearing LM8UU 8mm Ball Bearing for 3D Printer RepRap Prusa features:

- Measurements:
* Internal diameter: 8mm
* External diameter: 15mm
* Length: 24mm
- Enclosure material: anti-corrosion chrome steel
- Inner support material: technical plastic

This module is a three way switch ( COM, NO and NC ) that uses the intensity of the ambient light to control directly the load at the output. Its adjustment potentiometer allows changing the sensitivity and setting the start threshold of the relay. The relay is energized when it is darker than the threshold.

10x Female-Female Cables 20cm Jumpers Dupont 2,54 features:
-Length: 20cm
-Quantity: 10 cables
-Connectors have female header contacts at either end
-Compatible with male connectors 2,54mm
-High quality and good working conditions
-Easy to install and use

Industrial Abrasive Scourer Pad 150x50mm Laminated Copper Plate PCB features:
Industrial abrasive scourer for laminated copper plate Cleaner for cleaning the laminated copper plate. Perfectly removes impurities such as oxides, sulfides and other similar establishments, as well as polished surfaces so that the copper substrate is better prepared.
It is also ideal for removing the remains of enamels, lacquers and other materials used during the creation of PCB tracks.