JST Male Connector 15cm AWG18

Limit Switch with Wheel - 5A 250 Vac - 1 switched - Arduino features:
-Micro KW12-3 on / off switch
-Max Current: 5A -AC voltage: 125-250V
-Operating temperature: -40 to 70 degrees C
-Quantity: 2 units

RepRap Arduino Mega Pololu Shield (RAMPS) version 1.4 for 3D printer. RAMPS is a shield for the Arduino Mega - The outputs of the Arduino board are redirected to the motor drivers. To have the complete electronics for a 3D printer you need a RAMPS, an Arduino Mega and at least four stepper motor drivers

Ideal for projects with ARDUINO.
You can use it with PIC, AVR, STM32. LCD Display Screen 12864 128x64 Dots Graphic Blue Backlight features:
- Graphic LCD Screen 128x64 points
- 5V power
- Blue retro background illuminated, white letters
- Controller ST7920
- Parallel / serial communication
- Dimensions PCB 93x70mm

This module can handle 16 PWM signals, through an I2C connection with devices like microcontrollers or development boards like Arduinos.
It can also be concatenated with other equal modules (up to 62 cards), increasing versatility and allowing you to obtain up to 992 PWM outputs that can be used to connect servo motors or LEDs to change the brightness intensity.
PCA9685 digital servo motor controller 16 channel PWM features:

- Supply voltage: 3-5 VDC,
- Maximum motor voltage: 6 VDC,
- Number of channels: 16,
- Resolution per channel: 12 bits,
- Interface: I2C,
- Working frequencies: 40-1000 Hz,
- PCB size: 62.3x25.3mm .

1 Channel Relay Module DC 5V 10A Low/High Trigger for Arduino features:
- Channel: 1 (protected with Optocoupler)
- Supply voltage: 5V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- Trigger signal type jumper (low / high)
- LED indicator
- Dimensions: 30x 54mm
- Has a jumper that allows to choose type of trigger signal (low / high)
- This module can be controlled directly by the microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL)

TP4056 5V Micro USB Lithium Battery Charger Module features:
- Based on TP4056ES regulator
- Lipo micro USB Li-Ion charger
- Input Voltage: 4.5V - 5.5 VDC
- Full charge voltage: 4.2V +/- 1.5%
- Max Output Current: 1A
- Indicator LED: charging red, charging green
- Operating temperature: -10ºC to + 85ºC
- IN + and IN- connection for electronic circuits
- Battery protection against over-discharge voltage: 2.5V - Protection against over current battery: 3A
- Measurements: 25x19x5 mm
- Ideal for 18650 batteries

Load cell Load Cell Weight Sensor 10kg features:

Load range: 10kg

Operating voltage: 3VDC ~ 14 VDC.

Rated output: 1.0 ± 0.15mV/V.

Repeatability: 0.03% FS

Effect of temperature on output: 0.01% F.S / ° C

Temperature effect on zero: 0.05% F.S / ° C