Set of Crocodile Tweezers Probes Cables for Power Supply 30V 5A

25ft (7.62m) reels of 6-colour rigid jumper wire for electronics prototyping and breadboarding. 22AWG cross section (approx. 0.34mm2)

Characteristic: - Supports up to 280ºC
- Electrical and antistatic insulation
- Resistant to acid and alkaline products
- Resistant to solvent
- Adhesive
- Approx Length: 26m
- Polyamide adhesive tape 5mm x 26m
- Known as Kapton polyamide tape
- Product for welding works on those that need to protect some component from heat

40x Female-Female Cable 20cm features:
-Length: 20cm
-Quantity: 40 wires
-Dupont female connectors on both ends
-Compatible with 2.54mm male connectors
-High quality and good working condition
-Easy to install and use

Electronic Antistatic Wrist Bracelet ESD Blue features:
- Electronic Antistatic Bracelet, blue color
- Protection against electrostatic charges
- Adjustable bracelet with crocodile clip connector
- Material: The conductive elastic band is made of nylon and woven in stainless steel
- Extensible length up to 180 centimeters
- Weight: 25 gr.
- Quantity: 1 loose unit in plastic bag

- The electrical products and lubricants of the bearings
- Its working temperature is up to 30 °C Technical Vaseline for Contacts and Bearings 35g features:
- Solid product
- White color
- Specific smell
- Melting point: 56 °C
- Ignition temperature: 220 °C
- Density at 20 °C: 822 kg / m3
- Maximum temperature of use: 30 °C
- Solubility in water: partial

TP4056 Lithium Battery Charger Module 5V mini USB features:
- Based on TP4056ES regulator
- Lipo mini USB Li-Ion charger
- Input Voltage: 4.5V - 5.5 VDC
- Full charge voltage: 4.2V +/- 1.5%
- Max Output Current: 1A
- Indicator LED: charging red, charging green
- Operating temperature: -10ºC to + 85ºC
- IN + and IN- connection for electronic circuits
- Battery protection against over-discharge voltage: 2.5V - Protection against over current battery: 3A
- Measurements: 25x19x5 mm
- Ideal for 18650 batteries

In the case of a battery pack, the BMS (Battery Management System) balancing protection circuit allows charging and discharging to be individually controlled. That is, the circuit controls that all cells are charged and discharged at approximately the same voltage. The current during charging should be limited, because the cell will "absorb" the current given to it, but a higher current than the one established by the manufacturer (generally a safe current is 1C ) can cause the cell to overheat and, in extreme cases, explode. The same relationship also applies to discharge.

Liquid Flux Alcohol Base TK83 100ml 
Flux liquid alcohol based for electronic welding. Type of flux: rosin
No Clean, Lead Free, Non-conductive. Ideally suited for manual tinning to restore solderability. Solids content 24%. max. soldering temperature 280ºC.