Small Probe Test for Multimeter Red Color

10x Photoresistor 5mm GL5516 LDR 5-10k for Arduino.
Photoresistor is a resistor whose resistance decreases when increasing the intensity of the light that falls on it. 10x Photoresistor GL5516 LDR features:
- Model: GL5516
- Spectral peak: 540nm
- Maximum DC voltage: 150V
- Maximum power: 90mW.
- Resistance with light (10lux): 5-10KΩ
- Resistance with darkness (0lux): 0.5MΩ
- Response time: 20ms
- Operating temperature: -30ºC - 70ºC

12mm Bore Pillow Block Mounted Bearing is often suited to support rotating shaft applications.

Ideal for your electronic projects, arduino, but can also be used with other microcontrollers. Breadboard Power Supply Protoboard 830/400 Points MB102 features:
- Input voltage supports up to 12V
- Selectable 3.3V or 5V
- USB input or standard DC 2.1 x5.5mm connector
- Maximum current 700mA
- It fits perfectly on the MB-102 breadboard feeding the two lateral buses
- Weight: 15 gr. (approx.) Compatible only with MB-102 type plates

40x Female-Female Cable 20cm features:
-Length: 20cm
-Quantity: 40 wires
-Dupont female connectors on both ends
-Compatible with 2.54mm male connectors
-High quality and good working condition
-Easy to install and use

The USB (Universal Serial Bus), is an industrial standard bus that defines the cables, connectors and protocols used in a bus to connect , communicate and supply power between computers, peripherals and electronic devices.
This female type B USB connector adapter soldered on a PCB board is ideal for use in your projects.
It has connection points where you can easily solder some pins to connect it directly to a breadboard, or solder a cable over those same connection points.
USB Type B Female 2.0 Connector Adapter with PCB features:
- Connector type: USB Type B Female,
- Internal color: White,
- Nominal voltage: 30v DC,
- Maximum current: 1A DC,
- Insulation resistance: 1000Mohm,
- Operating temperature: -25ºC to + 85ºC,

Buzzer alarm to convert electrical to acoustic signals in robotics devices and Arduino projects.
Buzzer 5V Active Buzzer 4 to 7V DC features:

- Input voltage: 4V to 7V
- Diameter: 12mm
- Height: 9.5mm
- Spacing Pins: 7.6mm
- Maximum Current:

Test probe for oscilloscope, kit with all the material as spare part or additional cable. Ergonomic clamp with x10 or normal x1 attenuation.