Hook-up Wire SparkFun breadboard patch cable - White (22 AWG)

Also available with waterproof casing and 100cm cable and 200cm. DS18B20 Temperature Sensor TO-92 0.5ºC Precision 5V Integrated features:
- Device function: Temperature sensor
- Type of output: Digital
- Supply voltage: 3V to 5.5V
- Accuracy: ± 0.5ºC
- Temperature threshold: Programmable
- Operating temperature: -55ºC to + 125ºC
- Encapsulated: TO-92
- Supply current: 1.5mA

Resistor 220 Ohm 5% 0,25W 1/4W features:
-220 Ohm
-Type: Carbon film
-Tolerance: ±5%
-Power: 0.25W
-Dimensions: 2x7mm

Kit of Micro Steel Drill Bits to eliminate jams in nozzles of 3D printers, CNC
Characteristic:
- Diameter: 0.2 / 0.3 / 0.4 mm
- Shank diameter approx. 3,2mm
- Total length approx. 38mm
- Material: Steel
- Quantity: 10 units
- High quality drill bits for making custom nozzles or cleaning block nozzles
- 3D printer bits - Drilling and cleaning of nozzles - 0.2 0.3 0.4 mm - RepRap

LITHIUM POLYMER BATTERY Battery LIPO 2650mAh 3.7V features:
-Battery type-lithium polymer. - Type of battery terminals- 3 wires. -Voltage of the battery-3.7 V -Capacity of the battery- 2650 mAh. - Embedded PCM security chip (protection against overload, over discharge, short circuit). Dimensions: -Length / depth of the battery- 71 mm -Width / diameter of the battery- 95 mm It has three cables with a 3-pin connector with a separation of 2 mm. Cables: Red: positive. Black: negative. Yellow: thermistor output.

You can easily control any device over the Internet through your phone, computer, etc.
The module can handle 5 users at the same time, it can work in two modes: STA (client) and AP (access point).
In AP mode, the module is connected via WIFI directly to your phone or computer (in open field can be up to 300 meters).
In STA mode, the relay module is connected to the access point (router) that supplies the network.
Wi-Fi in the room where the relays are located. In this case, the range mainly depends on the power of the access point antennas (routers).
You should not turn off after the configuration is completed, as some of the parameters of the WIFI module cannot be saved when power is cut off.

Limit Switch with Wheel - 5A 250 Vac - 1 switched - Arduino features:
-Micro KW12-3 on / off switch
-Max Current: 5A -AC voltage: 125-250V
-Operating temperature: -40 to 70 degrees C
-Quantity: 2 units

25ft (7.62m) reels of 6-colour Strandedjumper wire for electronics prototyping and breadboarding. 22AWG cross section (approx. 0.34mm2)

Definition of the Hall effect: When a current passes through a bar of semiconductor (or conductive) material, and if an induction magnetic field B is applied perpendicularly to the direction of current flow, a voltage, called the Hall voltage, proportional to the magnetic field, and the current appears on the side faces of the bar.
This voltage is proportional to the speed of movement of the charge carriers, It is considerably higher in semiconductor materials than in metal conductors. Magnetic Sensor Characteristic: - Input Voltage: 3.8-30VDC - Output current: 40mA
High output current capacity -40 mA maximum absolute
Quad-Hall design virtually eliminates static mechanical effects
Magnetic compensated temperature - Digital current sinking output