RFID PN532 NFC Module with Card and Pendant NFC module for Educational STEAM Kit. Near field communication (NFC) is a set of standards for smartphones and similar devices to establish radio communication with each other by touching them together or bringing them into close proximity, usually no more than a few centimeters. Compatible with almost any microcontroller, Arduino, PIC, AVR. It can be used in Access Control projects and Alarm projects. RFID PN532 NFC Module with Card and Pendant features: - Support i2C, SPI, High Speed UART - Support RFID reading and writing - Support P2P communication with peers - Support NFC with phone - Work in NFC Mode or RFID reader/writer Mode - RFID reader/writer supports: - 1k, 4k, Ultralight, and DesFire cards ISO/> Code W0091 Available Price €8.26
BBC micro:bit V2.21 Go - Starter Pack The novelty of micro:Bit for a more lively introduction to technology for children. The micro:bit is a pocket computer that can be encoded, customized and controlled for the implementation of digital ideas and games. It measures just 4x5cm and features a fun and easy to use design, so users can create anything from games and animations to slick stories at school, at home or anywhere - all it takes is imagination and creativity. It is fully programmable. This means that each of its LEDs can be individually programmed as can its buttons, inputs and outputs, accelerometer, magnetometer, Bluetooth 5.0 technology, microphone and speaker. It contains a quick start guide in the same package. Code B0125 Available Regular price €19.79 -€0.96 Price €18.83
Sensor SCT-013-030, Non-Invasive 30A AC Current Meter The sensor measures the current flowing in the cable without cutting it. The measurement is made on a single insulated wire, the output is an analog voltage from 0 to 1 V. Sensor SCT-013-030, Non-Invasive 30A AC Current Meter features: Input current: 0 to 30A AC Output voltage: 0 to 1 V AC Built-in load resistance: 62 Ω Winding ratio: 1800: 1 Operating temperature range: -25 ° C to 70 ° C Cable length: 1 m Sensor weight: approximately 45 g Sensor SCT013-030 datasheet Code M0203 Available Price €5.36
Green silicone protective cover for BBC Micro:Bit Protective cover used for micro: bit. The cover has two different sides, dot matrix display area, finger usage area on the front. Micro USB interface, power interface and reset button on the back side. It can be installed on a micro: bit board to make your work more charming and fun. Weight: 10g Size: 5,65 cm * 3,7 cm Material: gel silica (environmental protection material) Code RA139 ✗ Out-of-Stock Price €3.72
2 Double Side Prototype PCB Board 6x8cm 2 Double Side Prototype PCB Board 6x8cm features: -Thickness of PCB: 1.6mm-Material: high quality FR-4 glass fiber PCB-Presented and numbered on both sides-Top and bottom are identical copper layers-Pads grid (pitch) 2.54mm/0.1", hole diameter 0.9mm Code PB026 Available Price €0.82
Raspberry Pi 5 Megapixel Camera Module The Raspberry Pi High Definition (HD) camera board connects to any Raspberry Pi or Compute Module to create HD photos and video. Code RA073 Available Price €7.40
USBASP Atmega8 AVR Programmer Atmega128 Arduino compatible Adapter Cable Characteristic: - AVR 5V / 3.3V microcontrollers - change the programming voltage through jumper JP1 - LED status indicators - Transmission speed: 5kB / s - Fuse protector against possible damage to the USB port - Supported OS: Win ME, Win XP, Vista, Win 7, Win8, Linux - Works with Bascom, Eclipse, WINAVR, avrDUDE, ARDUINO IDE, ATMEL STUDIO The programmer is compatible with most AVR Atmel processors: - MEGA series 8,16,32,64,218 € ¦ - Tiny series: ATtiny10, ATtiny11, ATtiny12, ATtiny13, ATtiny13A, ATtiny15 € ¦ - CAN series: AT90CAN32, AT90CAN64, AT90CAN128 € ¦ - AT90S2313 series, AT90S2323, AT90S2343, AT90S4414, AT90S4433 € ¦ Code B0029 Available Price €5.45
DC 12V 4 Chanel RF Wireless Remote Control Switch System The four-way wireless smart receiving controller features four relays, which can control on / off as a switch for various special control applications. The product has the characteristics of stable performance, small size and high reception sensitivity. It is mainly used in electric doors, windows, lifting equipment, security and control systems etc. The controller supports a variety of different wireless remote controllers, such as 2262/2260/1527/2240. Code W0101 Available Price €10.54
Smart Cutebot : Smart car robot kit for micro:bit Elecfreaks Cutebot is a car with a dual-speed motor and smart coding that packs a lot of power. Children can learn micro:bit from simple to complex. They use programming to get what they want. Enhances children's interest in programming. Note: the micro:bit board is not included, you can buy it separately. The car is ready to use. All that remains is to mount the sensor and the battery holder. Note: micro:bit board is not included, you can buy it separately. Code EL0103 ✗ Out-of-Stock Price €32.98
Ring:bit Car v2 Kit : DIY programming smart car for micro:bit The ELECFREAKS Ring:bit Car is a small DIY smart car powered by the BBC micro:bit. Manual installation can better exercise children's skills. The makecode graphical programming blocks allow children to learn programming from simple to complex in a fun way. Note: the micro:bit board is not included, you can buy it separately. All modules have convenient connectors to use them and no soldering is required. Code EL0102 Available Price €24.37
Maqueen Mechanic DFRobot Maqueen Mechanic is an expanded expansion pack for micro:Maqueen. It contains more than 20 types of mechanical parts that allow Maqueen to change its shape. Code DF022 Last items in stock Price €49.55
Gravity: Analog pH Sensor/Meter Kit DFRobot Gravity (SEN0161): The analogue pH meter is specifically designed to measure the pH of the solution and reflect the acidity or alkalinity. The DFRobot ph sensor is commonly used in various applications such as aquaponics, aquaculture and environmental water testing. The pH is a value that measures acidity or alkalinity. Code DF024 Last items in stock Price €37.93
Protoboard GPIO T-type Extension Board for Micro:Bit Connect this extension board to the micro: bit development board, then they can be directly connected to the breadboard. Code RA043 ✗ Out-of-Stock Price €6.20
Blue silicone protective cover for BBC Micro:Bit Protective cover used for micro: bit. The cover has two different sides, dot matrix display area, finger usage area on the front. Micro USB interface, power interface and reset button on the back side. It can be installed on a micro: bit board to make your work more charming and fun. Weight: 10g Size: 5.5 cm * 6.5 cm Material: gel silica (environmental protection material) Code RA045 ✗ Out-of-Stock Price €4.13
Robot Maqueen Lite - Forklift Let´s equip Maqueen with this mechanical forklift kit so he can simulate the movement of a forklift. Program it to lift an object, fork and transfer items, just like a real forklift in a factory. Compatible with Maqueen Lite and Maqueen Plus. This play and learn kit comes with a wealth of mechanical knowledge, which will allow students to benefit greatly from hands-on practice. Come and find the most fun and interesting ways to play with Maqueen in this kit. Code DF008 ✗ Out-of-Stock Price €18.10
T-type Protoboard GPIO Extension Board for Micro:Bit with 5V and 3.3 V output GPIO breadboard extension board for Micro:Bit enables direct connection to the breadboard. The connection is very intuitive - you will have everything set up in seconds. It makes it easy to connect sensors and modules. An additional advantage of this board is the separate 5V and 3.3V supply pins. This makes it possible to use larger groups of sensors and modules. Code RA166 Available Regular price €7.81 -€1.00 Price €6.81
Smart Science IoT Kit : micro:bit climate sensor kit for IoT learning ELECFREAKS Smart Science IoT Kit is developed on the basis of loT:Bit, a new breakout board compatible with ultrasonic sensor, dust sensor, light sensor and water level sensor, including RTC Timing and WIFI module. It can build the scene such as air quality monitoring, environmental noise detection, environmental quality monitoring station, automatic watering detection, self-defence monitoring station and more. Code EL0109 ✗ Out-of-Stock Price €61.07
GamePad for micro:bit (V4.0) GamePad for micro:bit V4.0 adopts a high-precision three-axis analog quantity joystick. The combination of joystick and gamepad allows you to control the direction and speed of Maqueen at the same time. In addition, there are 7 programmable buttons, which means you can explore more interesting functions and more flexible controls. In the latest V4.0 product, we have placed the external battery box on the PCB, which is more convenient to use. Code DF009 Available Price €20.62
Smart Cutebot : Smart car robot kit for micro:bit Elecfreaks Cutebot is a car with a dual-speed motor and smart coding that packs a lot of power. Children can learn micro:bit from simple to complex. They use programming to get what they want. Enhances children's interest in programming. Note: the micro:bit board is not included, you can buy it separately. The car is ready to use. All that remains is to mount the sensor and the battery holder. Note: micro:bit board is not included, you can buy it separately. Code EL0103 ✗ Out-of-Stock Price €32.98
Ring:bit Car v2 Kit : DIY programming smart car for micro:bit The ELECFREAKS Ring:bit Car is a small DIY smart car powered by the BBC micro:bit. Manual installation can better exercise children's skills. The makecode graphical programming blocks allow children to learn programming from simple to complex in a fun way. Note: the micro:bit board is not included, you can buy it separately. All modules have convenient connectors to use them and no soldering is required. Code EL0102 Available Price €24.37
Maqueen Mechanic DFRobot Maqueen Mechanic is an expanded expansion pack for micro:Maqueen. It contains more than 20 types of mechanical parts that allow Maqueen to change its shape. Code DF022 Last items in stock Price €49.55
Gravity: Analog pH Sensor/Meter Kit DFRobot Gravity (SEN0161): The analogue pH meter is specifically designed to measure the pH of the solution and reflect the acidity or alkalinity. The DFRobot ph sensor is commonly used in various applications such as aquaponics, aquaculture and environmental water testing. The pH is a value that measures acidity or alkalinity. Code DF024 Last items in stock Price €37.93
Protoboard GPIO T-type Extension Board for Micro:Bit Connect this extension board to the micro: bit development board, then they can be directly connected to the breadboard. Code RA043 ✗ Out-of-Stock Price €6.20
Blue silicone protective cover for BBC Micro:Bit Protective cover used for micro: bit. The cover has two different sides, dot matrix display area, finger usage area on the front. Micro USB interface, power interface and reset button on the back side. It can be installed on a micro: bit board to make your work more charming and fun. Weight: 10g Size: 5.5 cm * 6.5 cm Material: gel silica (environmental protection material) Code RA045 ✗ Out-of-Stock Price €4.13
Robot Maqueen Lite - Forklift Let´s equip Maqueen with this mechanical forklift kit so he can simulate the movement of a forklift. Program it to lift an object, fork and transfer items, just like a real forklift in a factory. Compatible with Maqueen Lite and Maqueen Plus. This play and learn kit comes with a wealth of mechanical knowledge, which will allow students to benefit greatly from hands-on practice. Come and find the most fun and interesting ways to play with Maqueen in this kit. Code DF008 ✗ Out-of-Stock Price €18.10
T-type Protoboard GPIO Extension Board for Micro:Bit with 5V and 3.3 V output GPIO breadboard extension board for Micro:Bit enables direct connection to the breadboard. The connection is very intuitive - you will have everything set up in seconds. It makes it easy to connect sensors and modules. An additional advantage of this board is the separate 5V and 3.3V supply pins. This makes it possible to use larger groups of sensors and modules. Code RA166 Available Regular price €7.81 -€1.00 Price €6.81
Smart Science IoT Kit : micro:bit climate sensor kit for IoT learning ELECFREAKS Smart Science IoT Kit is developed on the basis of loT:Bit, a new breakout board compatible with ultrasonic sensor, dust sensor, light sensor and water level sensor, including RTC Timing and WIFI module. It can build the scene such as air quality monitoring, environmental noise detection, environmental quality monitoring station, automatic watering detection, self-defence monitoring station and more. Code EL0109 ✗ Out-of-Stock Price €61.07
GamePad for micro:bit (V4.0) GamePad for micro:bit V4.0 adopts a high-precision three-axis analog quantity joystick. The combination of joystick and gamepad allows you to control the direction and speed of Maqueen at the same time. In addition, there are 7 programmable buttons, which means you can explore more interesting functions and more flexible controls. In the latest V4.0 product, we have placed the external battery box on the PCB, which is more convenient to use. Code DF009 Available Price €20.62