Photoresistor GL5516 LDR 10x Photoresistor 5mm GL5516 LDR 5-10k for Arduino.Photoresistor is a resistor whose resistance decreases when increasing the intensity of the light that falls on it. 10x Photoresistor GL5516 LDR features: - Model: GL5516- Spectral peak: 540nm- Maximum DC voltage: 150V- Maximum power: 90mW.- Resistance with light (10lux): 5-10KΩ- Resistance with darkness (0lux): 0.5MΩ- Response time: 20ms- Operating temperature: -30ºC - 70ºC Code S0012 Available Price €0.12
5V Stepper Motor 28BYJ-48 + ULN2003 Driver The 28BYJ-48 has everything you need to start using stepper motors in your projectA stepper motor converts digital impulses into small steps of movement in one direction The engine also comes with a ULN2003 engine controller cardCan control two DC motors or a bipolar stepper motor with a maximum amperage of up to 500 mAEquipped with state indicator LEDs A, B, C, D 5V Stepper Motor 28BYJ-48 + ULN2003 Driver Boat features: - Engine model: 28BYJ-48- Phases engine: 4- Operating voltage: 5V- Frequency: 100 Hz- Operating current: 200mA- Max Power: 20W- Winding resistance: 70 ohm- Angle per step: 5,625º- Steps per round: 64- Torque: 0.3 Kgr / cm- Speed: 1900 rpm Code R0038 Available Price €2.44
Grove - Universal 4 Pin 20cm Unbuckled Cable (5 PCs Pack) These cables are compatible with all modules included in the Grove system, quick connect for modules, sensors and more. 5 cables are included in this package. Forget soldering and bad connections. Code SS019 Available Regular price €2.06 -10% Price €1.85
5V 2A USB-C lithium battery charger module The high-precision 5V2A charger for Li-Ion 18650 batteries has a USB-C connection for powering the module. It is also equipped with a USB-A connection for charging. Code A0171 Available Price €1.61
ATmega2560 R3 REV3 16U2 Mega2560 module with USB cable It has an Atmega2560 chip running at 16Mhz with a factory loaded bootloader with 54 digital input / output pins (from which 14 can be used as PWM outputs) and 16 analog inputs, 4 UART (hardware serial ports). The board includes a USB connector, an ICSP port, a reset button and some status LEDs. Atmega16U2 programmed as a USB-to-serial converter. Simply connect it to a computer with a USB cable or power with a power adapter and DC connector. Code B0003 Available Price €20.58
Kit Beetle - Robot Maqueen The Maqueen Mechanic-Beetle kit includes a metal servo, mechanical parts, screws and more. With a simple installation, your Maqueen car is ready to go. Use this kit to turn your Maqueen Lite and Maqueen Plus into a Mechanic Beetle! This play and learn kit comes with a wealth of mechanical knowledge. Come and find the most fun and interesting ways to play with Maqueen in this kit. Code DF006 ✗ Out-of-Stock Price €12.31
64GB Class 10 MicroSD memory card with adapter 64GB Class 10 MicroSD memory card with adapter features: - 64GB capacity - Class 10 - MicroSD dimensions 11mm x 15mm x 1mm - FAT32 format - Operating temperature -25 ° C to 85 ° C - Storage temperature -40 ° C to 85 ° C - Voltage 3.3 - Includes adapter Code V0015 Available Price €8.10
2x AAA 3V battery holder for Micro:bit Weight: 12.7g Box size: 62 * 25 * 10 mm Code PP037 Available Price €1.64
BBC micro:bit V2.21 - WiFi Single Board Micro-Computer, BLE 5.0, Microphone + Speaker + Accelerometer The novelty of micro:Bit v2.21 for a more lively introduction to technology for children. The micro:bit is a pocket computer that can be encoded, customized and controlled for the implementation of digital ideas and games. It measures just 4x5cm and features a fun and easy to use design, so users can create anything from games and animations to slick stories at school, at home or anywhere - all it takes is imagination and creativity. It is fully programmable. This means that each of its LEDs can be individually programmed as can its buttons, inputs and outputs, accelerometer, magnetometer, Bluetooth 5.0 technology, microphone and speaker. It contains a quick start guide in the same package. Code B0120 Available Regular price €17.31 -€1.00 Price €16.31
Joystick Breakout Board for BBC Micro:Bit The joystick board can be used to simulate the mouse keyboard. The 3V, G, P0 and P1 are connected to a card micro: bit to imitate the serial port. This board consists of 6 buttons and joystick. Connect the joystick and buttons to the micro: bit pins. Code RA040 Available Price €8.22
Keyestudio Microbit Starter Smart Home Kit This smart home kit is based on the open source micro:bit hardware and is intended for those who want to create smart home projects that improve the comfort of the home through technology. The kit has been launched by Keyestudio. The kit does not include the micro:bit board. Code RA170 Available Regular price €68.59 -€9.03 Price €59.56
Seeed Grove Inventor Kit for micro:bit The Grove inventor kit is a great extension set for your micro:bit. By using Grove shield for micro:bit you are able to connect all the modules included in the pack purely by the Grove connectors with no need to solder or wire any parts. Now you can focus only on programing with your great mirco:bit. Code SS005 Available Regular price €57.77 -€20.00 Price €37.77
ELECFREAKS BitBoard Kit Turn everything into a "keyboard" thanks to the Bitboard. Code EL0117 Available Regular price €29.67 -€6.00 Price €23.67
Retro Makecode Arcade For Education The RETRO Arcade for Education is the first large-screen arcade device with high resolution. Children can use it to fuel their creativity by easily creating their games while having fun playing. Code EL0114 ✗ Out-of-Stock Price €49.50
Robot Maqueen Plus V2 for micro:bit Maqueen Plus V2 is the latest version of the STEAM educational robot. Maqueen Plus (DFRobot MBT0021) is optimised with more expansion ports, a higher capacity power supply and a larger body and is fully compatible with peripheral components. This makes it an accessible STEAM robot teaching tool for primary and secondary school students. Code DF012 Last items in stock Price €56.60
Yellow silicone protective cover for BBC Micro:Bit V2 Protective cover used for micro: bit. The cover has two different sides, dot matrix display area, finger usage area on the front. Micro USB interface, power interface and reset button on the back side. It can be installed on a micro: bit board to make your work more charming and fun. Weight: 10g Size: 5,65 cm * 3,7 cm Material: gel silica (environmental protection material) Code RA137 ✗ Out-of-Stock Price €3.72
Ring:bit 6 IN 1 Pack : Bricks pack - building and coding kit for micro:bit Six cases of fun in one kit: kids can build 6 shapes, including traffic lights, brick car, temperature-controlled fans, smart desk lamp, windscreen wiper and trebuchet. Building with this kit is just as easy as building with Lego. Note: the micro:bit board is not included, you can buy it separately. Code EL0104 Backorder Price €48.68
Green silicone protective cover for BBC Micro:Bit Protective cover used for micro: bit. The cover has two different sides, dot matrix display area, finger usage area on the front. Micro USB interface, power interface and reset button on the back side. It can be installed on a micro: bit board to make your work more charming and fun. Weight: 10g Size: 5,65 cm * 3,7 cm Material: gel silica (environmental protection material) Code RA139 ✗ Out-of-Stock Price €3.72
BBC micro:bit V2.21 - WiFi Single Board Micro-Computer, BLE 5.0, Microphone + Speaker + Accelerometer The novelty of micro:Bit v2.21 for a more lively introduction to technology for children. The micro:bit is a pocket computer that can be encoded, customized and controlled for the implementation of digital ideas and games. It measures just 4x5cm and features a fun and easy to use design, so users can create anything from games and animations to slick stories at school, at home or anywhere - all it takes is imagination and creativity. It is fully programmable. This means that each of its LEDs can be individually programmed as can its buttons, inputs and outputs, accelerometer, magnetometer, Bluetooth 5.0 technology, microphone and speaker. It contains a quick start guide in the same package. Code B0120 Available Regular price €17.31 -€1.00 Price €16.31
Joystick Breakout Board for BBC Micro:Bit The joystick board can be used to simulate the mouse keyboard. The 3V, G, P0 and P1 are connected to a card micro: bit to imitate the serial port. This board consists of 6 buttons and joystick. Connect the joystick and buttons to the micro: bit pins. Code RA040 Available Price €8.22
Keyestudio Microbit Starter Smart Home Kit This smart home kit is based on the open source micro:bit hardware and is intended for those who want to create smart home projects that improve the comfort of the home through technology. The kit has been launched by Keyestudio. The kit does not include the micro:bit board. Code RA170 Available Regular price €68.59 -€9.03 Price €59.56
Seeed Grove Inventor Kit for micro:bit The Grove inventor kit is a great extension set for your micro:bit. By using Grove shield for micro:bit you are able to connect all the modules included in the pack purely by the Grove connectors with no need to solder or wire any parts. Now you can focus only on programing with your great mirco:bit. Code SS005 Available Regular price €57.77 -€20.00 Price €37.77
ELECFREAKS BitBoard Kit Turn everything into a "keyboard" thanks to the Bitboard. Code EL0117 Available Regular price €29.67 -€6.00 Price €23.67
Retro Makecode Arcade For Education The RETRO Arcade for Education is the first large-screen arcade device with high resolution. Children can use it to fuel their creativity by easily creating their games while having fun playing. Code EL0114 ✗ Out-of-Stock Price €49.50
Robot Maqueen Plus V2 for micro:bit Maqueen Plus V2 is the latest version of the STEAM educational robot. Maqueen Plus (DFRobot MBT0021) is optimised with more expansion ports, a higher capacity power supply and a larger body and is fully compatible with peripheral components. This makes it an accessible STEAM robot teaching tool for primary and secondary school students. Code DF012 Last items in stock Price €56.60
Yellow silicone protective cover for BBC Micro:Bit V2 Protective cover used for micro: bit. The cover has two different sides, dot matrix display area, finger usage area on the front. Micro USB interface, power interface and reset button on the back side. It can be installed on a micro: bit board to make your work more charming and fun. Weight: 10g Size: 5,65 cm * 3,7 cm Material: gel silica (environmental protection material) Code RA137 ✗ Out-of-Stock Price €3.72
Ring:bit 6 IN 1 Pack : Bricks pack - building and coding kit for micro:bit Six cases of fun in one kit: kids can build 6 shapes, including traffic lights, brick car, temperature-controlled fans, smart desk lamp, windscreen wiper and trebuchet. Building with this kit is just as easy as building with Lego. Note: the micro:bit board is not included, you can buy it separately. Code EL0104 Backorder Price €48.68
Green silicone protective cover for BBC Micro:Bit Protective cover used for micro: bit. The cover has two different sides, dot matrix display area, finger usage area on the front. Micro USB interface, power interface and reset button on the back side. It can be installed on a micro: bit board to make your work more charming and fun. Weight: 10g Size: 5,65 cm * 3,7 cm Material: gel silica (environmental protection material) Code RA139 ✗ Out-of-Stock Price €3.72