Power Supply Transformer 220V AC/12V DC 1A

The L293D motor controller allows you to control two DC motors or one stepper motor using Arduino kits. The system allows you to adjust the direction and rotational speed of motors with a current consumption of up to 600 mA and a supply voltage from 4.5 V to 25 V.

10x Linear Potentiometer 100k OHM kΩ features:
- 100k Ohm kΩ Linear
- Horizontal variable resistance PCB
- Quantity: 10 units

The GY-906 BAA is a plate-mounted temperature sensor, based on an integrated 3 V infrared thermometer, single zone, medical precision, compensated gradient, within 3 cm the precision is higher, approximately 0.5 degrees

1 Channel Relay Module DC 5V 10A Low/High Trigger for Arduino features:
- Channel: 1 (protected with Optocoupler)
- Supply voltage: 5V
- Output Current: 10A
- Relay activation current: 15mA ~ 20mA
- Insulation: Yes
- Trigger signal type jumper (low / high)
- LED indicator
- Dimensions: 30x 54mm
- Has a jumper that allows to choose type of trigger signal (low / high)
- This module can be controlled directly by the microcontroller (Arduino, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL)

Double Side Prototype Copper PCB Board 2x8cm features:
-Thickness of PCB: 1.6mm
-Material: high quality FR-4 glass fiber PCB
-Presented and numbered on both sides
-Top and bottom are identical copper layers
-Pads grid (pitch) 2.54mm/0.1", hole diameter 0.9mm

15x Electrolytic Capacitor 1uF 50V 105º C PIC Arduino features:
-Type: Electrolytic Capacitor
-Assembly: intern
-Value: 1uF
-Maximum tension: 50V
-Maximum temperature: 105º C
-Dimensions: 5x11mm
-Quantity: 15 units

Red Laser Module 650nm 5mW Head Point Adjustable Focal Length features:
- Type: red laser diode
- Laser type: point
- Adjustable Focus
- Wavelength: 650nm
- Output power: 5mW
- Operating voltage: 4.5-5V
- Operating intensity: <40mA
- Operating temperature: -30ºC to 60ºC
- Dimensions of the emitter: Φ12x35mm
- Cable length: 130mm

Stepstick A4988 controller
Driver for stepper motors
Used with Ramps 1.4 - RepRapArduino Mega Pololu Shield
A4988 + Stepstick Radiator Stepper Motor Reprap features:

- Minimum operating voltage: 8 V
- Operating voltage maximum: 35 V
- Maximum current: ± 2 A (adequately ventilated or refrigerated)
- Logic voltage: 3 V / 5.5V
- Microstep resolution: full, 1/2, 1/4, 1/8, and 1/16
- Factory soldered temples
- Use potentiometer to adjust current
- Measurements: 20x16x12 mm